AIR CONDITIONERUse & Care GuideFor questions about features, operation/performance, parts, accessories or service call: 1-800-253-1301 Table of Co
10Top ViewComplete Installation1. Insert foam seal behind the top of the lower window sash and against the glass of the upper window.2. Place window-l
11Install Wood Frame1. Construct wood frame. See “Location Requirements” for dimensions.2. Measure outside width and height of frame to determine wall
12Attach Support Legs1. Determine the correct slots on the tray side from the type of exterior construction of the building.Thin wall construction (vi
132. Using 2 - #10 - 12 x 1¹⁄₂" slot-head wood screws, secure the tray-frame assembly to the wall opening.Left SideRight SideNOTE: If the exterio
142. If the feet on the bottom of the air conditioner do not rest on the wood strip, remove the air conditioner and adjust the SMART-MOUNT® tray until
15AIR CONDITIONER USEOperating your air conditioner properly helps you to obtain the best possible results. This section explains proper air condition
16Temperature Press the plus button to raise the temperature. Room indicator light will turn off, and Set indicator light will turn on. Display shows
17To Operate Air Conditioner with Remote ControlNOTE: Remote control may vary in appearance.NOTE: Two AA batteries (not included) power the remote con
18To set Timer to turn on air conditioner, changing the previous settings:1. Turn on air conditioner.2. Adjust Mode to Auto Cool, Cool, Fan Only, or P
19Models Without Power SaverModels With Power SaverTemperatureTurn the TEMPERATURE control to a mid-setting. Adjust the air conditioner's perform
2TABLE OF CONTENTSAIR CONDITIONER SAFETY ...2INSTALLATION REQUIREMENTS...
20AIR CONDITIONER CAREYour new air conditioner is designed to give you many years of dependable service. This section tells you how to clean and care
21TROUBLESHOOTINGBefore calling for service, try the suggestions below to see whether you can solve your problem without outside help.Air conditioner
22Air conditioner cycles on and off too much or does not cool The Mode is set to Power Saver (on some models). Use Power Saver only when you are asle
23ASSISTANCE OR SERVICEBefore calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you st
1188226B© 2005.All rights reserved.SMART-MOUNT is a trademark of Whirlpool, U.S.A.12/05Printed in U.S.A.
3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
4Window Installation Window opening measurements: 27" (68.6 cm) minimum to 40" (101.6 cm) maximum opening width. 19" (48.3 cm) minimu
5Power Supply CordNOTE: Your unit’s device may differ from the one shown.This room air conditioner is equipped with a power supply cord required by UL
6Window Installation1. Using the tray back as a template, center in windowsill against outside edge of stool.2. Using the 2 inside screw holes in tray
72. Insert carriage bolt up through slot on tray-frame side and support leg.3. Place one end of tray center over carriage bolt.4. Then place flat wash
8Prepare Air Conditioner for Window InstallationInstall Side CurtainsNOTE: Attach curtains to unit before placing unit in window.1. Insert curtain int
9Position the Air Conditioner in Window Handle air conditioner gently. Be sure your air conditioner does not fall out of the opening during install
Comments to this Manuals