Whirlpool WHE31352 F Instruction for Use

Browse online or download Instruction for Use for Unknown Whirlpool WHE31352 F. Whirlpool WHE31352 F User manual User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 5
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
INSTRUCTIONS FOR USE
GB
APPLIANCE DIAGRAM (Fig. 1)
A. Handle.
B. Safety closure (if provided).
C. Seal.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor ventilation grille.
CONTROL PANEL DIAGRAM (Fig. 2)
1. Red light: when blinking, it indicates an alarm
condition (see the section "TROUBLESHOOTING
GUIDE").
2. Blue light: when on, it indicates that the STOP FROST
function is activated (see the section "STOP FROST
FUNCTION")
3. Green lights: they indicate that the product is
working, the set temperature and possible activation of
the quick freeze function ("Shopping").
4. Setting button: for updating the set temperature,
activation/deactivation of the quick freeze function
("Shopping") and activation/deactivation of the "STOP
FROST" function.
BEFORE USING THE APPLIANCE
Your new appliance is designed to be used in the
household and similar applications such as:
- kitchen areas in shops, offices and other working
environments
- farm houses
- by clients in hotels, motels, residences, bed &
breakfasts.
The product must only be used to store frozen food, to
freeze fresh food and to make ice.
Regulations require the appliance to be earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property
resulting from failure to observe the above
procedures and reminders.
1. After unpacking, make sure that the appliance is
undamaged and that the door closes perfectly, with the
gasket remaining intact. Any damage must be reported
to your retailer within 24 hours after delivery of the
appliance.
2. Wait at least two hours before switching the appliance
on in order to ensure the refrigerant circuit is fully
efficient.
3. Installation and electrical connection must be carried
out by a qualified technician, according to the
manufacturer's instructions and local safety regulations.
4. Clean the inside of the appliance before using it.
Before connecting the appliance to the mains supply,
ensure that the voltage corresponds to that given on
the rating plate located on the rear of the appliance.
Electrical connections must be made in
accordance with local regulations.
INSTALLATION
Unpack the product.
Remove the 4 spacers inserted between the lid
and the product. (Fig 3)
Make sure the defrost water drain plug (if provided) is
correctly positioned (E).
For optimum operation and to avoid damage when the
lid is opened, maintain a distance of at least 7 cm from
the front wall and 7 cm at the sides. (Fig 4)
Insert the accessories (if provided).
STARTING THE PRODUCT
Connect the product to the power supply.
The green light ("Normal") comes on.
The red light (1) blinks, since the temperature inside
the product is not yet low enough for loading food.
This light normally goes off within six hours after
startup.
Place food inside only when the red light has gone off.
Note: If the STOP FROST function is deactivated, the lid
cannot be immediately reopened after closing it, because
the seal is tight. It is necessary to wait a few minutes
before reopening the lid.
TEMPERATURE ADJUSTMENT
Use the button (4) to select the required temperature. To
adjust the product temperature, proceed as follows:
Press the button (4). With each press of the button,
the set temperature will be changed cyclically between
the values "Eco", "Normal", "Intensive" and "Shopping".
Select "Intensive" for a colder storage temperature.
In case of a partial load, it is advisable to select "Eco"
to optimise energy consumption.
The green lights (3) indicate the selected setting as
follows:
Eco: less cold temperature (left
light on).
Normal: middle temperature
(right light on).
Intensive: very cold
temperature (both lights on).
Shopping: Quick Freeze (both
lights on blinking). See the
section "Freezing fresh food".
Note: In case of a power failure, the settings (except for
the "STOP FROST" function) remain stored. The time
required for the temperature inside the freezer to reach
approximately the set value may vary depending on the
climatic conditions and the setting selected.
STOP FROST FUNCTION
The STOP FROST function significantly reduces the
amount of frost that can form inside the product,
collecting it in the special easy to remove and clean "ICE
BOX" (M) container. STOP FROST technology also allows
easy reopening of the lid at any time whenever deemed
necessary, even repeatedly, always with the same effort.
Page view 0
1 2 3 4 5

Summary of Contents

Page 1 - INSTRUCTIONS FOR USE

INSTRUCTIONS FOR USEGBAPPLIANCE DIAGRAM (Fig. 1)A. Handle.B. Safety closure (if provided).C. Seal.D. Separator (if provided).E. Defrost water drain pl

Page 2

The STOP FROST function is already activated when theproduct is switched on the first time (blue light on). It canbe deactivated/reactivated by keepin

Page 3

consumption before the expiry dates listed in months inFig. 6 for each type of food.Advice for storing frozen foodWhen buying frozen food, make sure t

Page 4

appliance interior, do not use pointed or sharpmetal instruments to remove the ice.• Do not use abrasive products or heat up theinterior artificially

Page 5

Appliances with Isobutane (R600a): isobutane is a naturalgas without environmental impact, but is flammable.Therefore, make sure the refrigerant circu

Comments to this Manuals

No comments