Whirlpool CAE2745FQ Use and Care Manual download pdf (Page 10)

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

1. Refer to Installation Instructions to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet hoses.

Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through Normal cycle to clean washer and

remove antifreeze, if used. Use half the manufacturer’s

recommended amount of detergent for a medium-size

load.

Troubleshooting

If you experience Possible Causes Solution

Vibration or Shaking

Check the following for

proper installation or

see “Using Your

Washer” section.

Feet may not be in contact with the

oor and locked to cabinet.

Front and rear feet must be in rm contact with oor, and

washer must be level to operate properly.

Washer may not be level. Check oor for exing or sagging. If ooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See “Level the Washer” in Installation Instructions.

Load could be unbalanced or

twisted.

Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Wash smaller loads to reduce imbalance.

Do not tightly pack. Avoid washing single items.

Use Heavy Duty cycle for oversized, non-absorbent items such

as comforters or poly-lled jackets.

See “Cycle Guide” and “Using Your Washer” in this Use and

Care Guide.

Noises

Clicking or metallic

noises

Objects caught in washer drain

system.

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump.

It may be necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the basket.

Gurgling or humming Washer may be draining water. It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as nal amounts of

water are removed during the Drain & Spin cycles.

Humming Load sensing may be occurring. You may hear the hum of the sensing spins after you have

started the washer. This is normal.

Water Leaks

Check the following for

proper installation:

Washer not level. Water may splash off basket if washer is not level. Check that

load is not unbalanced or tightly packed.

Fill hoses not attached tightly. Tighten ll-hose connection.

Before calling for service on your washer, please try the solutions suggested in this section.

1 ... 9 10 11 ... 32

Comments to this Manuals

No comments

Whirlpool CAE2745FQ Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Washing machines Whirlpool CAE2745FQ