Whirlpool ADG 522 X Instruction for Use download pdf (Page 36)

Notes:

Optimumperformance levels when using the “1 Hour” and

“Rapid”cycles can be achieved by respectingthe specified

number of place settings.

To reduce consumption even further, only run the dishwasher

when it is full.

Note for Test Laboratories:

forinformationoncomparativeEN

testing conditions, please send an email to the following address:

[email protected]

Special wash cycles

and Options

Wash options

If an option is not compatible with the selected wash cycle

(see table of wash cycles), the corresponding LED flashes

rapidly 3 times and beeps will sound.

Tablet option (Tab)

This option optimises washing and drying results.

Whenusing Tablet, press theTABLET button; the

corresponding symbol will light up. If the button is pressed again,

the option will be deselected.

The “Tablet” option results in a longer wash cycle.

Start Delay option

The start of the wash cycle may be delayed for a period

of time between 1 and 12 hours.

1.PresstheSTARTDELAYbutton:thecorrespondingsymbol

appears on the display; each time you press the button, the time

(1h,2h,etc.uptomax.12h)fromthestartoftheselectedwash

cycle will be increased.

2.Select the cycle and closethe door: the timer will begin

counting down;

3.Oncethistimehaselapsed,theindicatorlightswitchesoff

and the wash cycle begins.

To adjust the delay time and select a smaller period of time,

presstheSTARTDELAYbutton.Tocancelit,pressthebutton

repeatedly until the selected delayed start indicator light switches

off. The wash cycle will start automatically as soon as the door

is shut.

The Start Delay function cannot be set once a wash cycle

has started.

Multizone Option

If there are not many dishes to be washed, a half load

cycle may be used in order to save water, electricity and

detergent.SelectthewashcycleandthenpresstheMULTIZONE

button: the indicator corresponding to the chosen rack lights up

and the wash cycle starts only in the upper or lower rack.

Remember to load the upper or lower rack only, and to

reduce the amount of detergent accordingly.

LIGHT POINT

Somedishwashermodelsareequippedwithagreenindicator

light in the gap between the door and kitchen top providing

information on the phase of the current wash cycle. One of the

following operating modes can be selected:

a) Disabled function

b) When the cycle starts the light goes on for few seconds, stays

offduringthecycleandflashesattheendofthecycle(default

mode)

c) The light stays on during the cycle and flashes at the end of

the cycle. If the delayed start was set, the light goes on either

for the first few seconds or the entire duration of the countdown,

based on whether mode b) or c) was set.

The light goes off every time the door is opened.

To select the mode you prefer, switch on the machine, hold

down button P until one of the three letters appears on the dis-

play, press button P

untilyoureachthedesiredletter(ormode),

hold down button P to confirm the selection.

Turbo Option

This option can be used to reduce the duration of

the main wash cycles while, maintaining the same washing

and drying performance levels. After selecting the wash cycle,

press the Turbo option button; the illumination of the corre-

sponding indicator light indicates its selection. Press it again

to deselect it.

Extra Dry Option

To improve the dryness level of the crockery, press the

ExtraDrybuttonandthesymbolwilllightup.Ifitispressedagain,

the option will be deselected.

A higher temperature during the final rinsing and a longer drying

phase improve the dryness level.

The Extra Dry option increases the duration of the wash cycle.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

Comments to this Manuals

No comments

Whirlpool ADG 522 X Instruction for Use Page 36

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool ADG 522 X