Whirlpool ADG 676/1 FD Instruction for Use download pdf

-1-

Chart

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the indicator of the required programme lights

up (see “Table of programmes” below).

BUTTON

OFF

BUTTON

START BUTTON

The indicator lights up during operation, flashes when a fault occurs and goes off at

the end of the programme.

START BUTTON RESET FUNCTION

Press this button for at least 2 seconds; the selected programme and options are

cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be

cancelled by RESETTING. Detailed instructions are given in chapter “What to do if...”.

(see at right for options description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions

(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible

with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: fo

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“[email protected]”.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions

Litres kWh

Minutes

AutoSensor 50-65°C

Delay

Recommended programme for

routine washes, with dried-on

food (e.g. EN 50242).

X 13-19 1.15-1.50 100-130

Quickwash 40°C

Delay

Lightly soiled crockery, with

no dried-on food. * Use of

tablets not recommended.

X * 13.0 0.70 30

Bio

50°C

Delay

Normally soiled crockery.

Energy-saving programme.

X 15.0 1.05 165

Intensive 70°C

Delay

Recommended programme

for heavily soiled crockery,

especially suitable for pots and

pans.

X 17.0 1.65 145

Half Load 50°C

Delay

Ideal for washing a half load of

lightly or normally soiled

crockery.

X 13.0 1.00 130

5019 396 01797ADG 676

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE ASSEMBLY

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

TIME AND FAILURE DISPLAY

With “Delayed start” selected, it indicates the time remaining until the start of the

programme (hh). Toward the end of the programme, during the drying cycle, the display

will indicate the time remaining in minutes.

If “F..” appears on the display, see chapter “What to do if...”.

RINSE AID INDICATOR

When lit, the rinse aid

dispenser needs to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

DELAYED START BUTTON

The wash cycle can be programmed to start after 1- 24 hours (with each successive touch

of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00).

Then press the START button. The dishwasher will start at the set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01797ADG 676

GB -1-ChartPROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the indicator of the required programme lights up (see “Table of programmes”

Page 2 - First time use

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3

GB -3-Daily check ELSSELELSELS123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt

Page 4 - How to load the racks

GB -4-How to load the racksHow to load LOWER RACK4(In some models only)A - Dish holder: In horizontal position for cups/long utensils. In raised posit

Page 5

GB -5-Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating678Exercise caution when opening the door:

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faul

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap.Contact the Af