Whirlpool is a registered trademark of Whirlpool USA
5019 396 01146
1
GB
ADG 686
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on
the EN comparison test and other
tests, contact the following address: “[email protected]”.1. OVERVIEW
Programme selector
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme and
options are cancelled. Main failure displays (repeated flashing of the
START indicator lamp) can be cancelled by RESETTING. Detailed
instructions are given in chapter 5 “What to do if...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
If “F..” appears on the display, see chapter 5 “What to do if...”.
Delayed start” button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
Detergent setting upon initial use and when using a different type of detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
Display shows OFF = Powder detergent (factory setting).
(rinse aid level and salt level indicator activated).
4. Switch the appliance off and then switch it on again. The selected detergent
type will be indicated on the display for approx. 3 sec .
On / Off button
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Loading instructions large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. — — 4.0 0.03 14 ±
1)
2
Quickwash 40°C
Lightly soiled crockery, without dry
residuals.
X — 10.0 0.65 30 ±
1)
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 11.0 1.05 155 ±
1)
4
Intensive 70°C
Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans.
X X 14.0 1.55 155 ±
1)
5
Half Load 50°C
Ideal for washing a half load of lightly or
normally soiled crockery.
X X 10.0 1.04 145 ±
1)
Comments to this Manuals