EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the
cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push Start button and close the
door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions.
Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test
and other tests, contact the following address: “contact@whirlpool.com”.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
6th Sense
Power Clean
40-70°C
Delay
Power Clean
Use for normal soiled dishes with dried-on food. Senses
the level of soiling on the dishes and adjusts the program
accordingly. When the sensor is detecting the soil level an
animation appears in the display and the cycle duration is
updated. The Power Clean option is activated automatically
with this program. To deactivate, press the Power Clean
button on the control panel.
X 7-15 1.00-1.70 70-172 Full
P2 Pre-Wash cold
Delay
Crockery to be washed later.
— 4.0 0.01 14-16 NO
P3 Fragile 40°C
Delay
Light soiling, for example glasses and cups.
X 10.5 0.85 105-114 Light
P4 Rapid 45°C
Delay
Lightly soiled crockery, with no dried-on food.
X 11.0 0.85 30-50 NO
P5
Eco
2)
50°C
Delay
Power Clean
Normally soiled crockery.
Standard Program the most efficient in terms of its
combined energy and water consumption.
X 10.0 0.92 240 Full
P6 Fast Daily 60°C
Delay
Normally soiled crockery.
X 11.0 1.30 80-95 Full
P7 Silent 50°C
Delay
Normally soiled crockery, gentle and quiet thanks to the
lower spray pressure (39 dbA).
X 14.0 1.20 290-299 Light
P8 Intensive 65°C
Delay
Power Clean
Recommended program for heavily soiled crockery,
especially suitable for pans and saucepans.
X 15.0 1.60 165-175 Full
P9 Steam
Delay
Power Clean
Program including steam action dedicated for heavily soiled
crockery, pots and pans. Soaking or hand pretreatment is
no longer needed.
X 14.5 1.75 180-190 Full
P10 Hygiene
Delay
Power Clean
Normally or heavily soiled crockery, with additional
antibacterial wash. Program interruption (e.g. due to door
opening) can compromise elimination of germs.
X 14.0 1.40 110-120 Full
5019 300 00822
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE
CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER
30 SECONDS IF NO CYCLE HAS STARTED.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle), the
rinse aid dispenser needs to be
refilled.
TABLET SETTING
This setting allows to
optimize the cycle
performances according the
type of detergent used.
Push the Tablet button for
3 seconds (until the indicator
lights up)
if you are using the combined
detergents in tablet (rinse
aid, salt and detergent in
1dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control panel
has to be off.
DELAYED START BUTTON
Push the button (repeatedly)
to delay the start of the
program.
Adjustable from 1 to 24
hours.
With each press of the
button, the delayed start
indicator increases by one
hour and after 24 restarts
from 0.
Then press the START
button.
The dishwasher will start
after the set time.
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area.
This option is recommended
for washing pots and
casseroles (see page 4).
Press this button to activate
Power Clean (the indicator
lights up).
For non Power Clean loading
to achieve best cleaning
performances and resources
optimization, Power Clean
should be switched off.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
(8 pages)
(8 pages)
(26 pages)
(8 pages)
(31 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals