Whirlpool ADG 7643/1 A++ Instruction for Use download pdf

EN -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle, the

cycle is temporarily paused: the Start indicator blinks.

To resume the cycle push Start button and close

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without available options) and may vary depending on conditions.

Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test

and other tests, contact the following address: “contac[email protected]om”.

* Power consumption in: Left-on mode: 0.70 W Off mode: 0.40 W

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40°-70°C

Delay

Half Load

Recommended program for routine

washes, with dried-on food

(e.g. EN 50242).

X 7-14 1.00-1.70 70-172 Full

Pre Wash cold

Delay Crockery to be washed later. – 4.0 0.01 14-16 NO

Fragile 40°C

Delay Light soiling, for example glasses and cups. X 10.5 0.85 105-114 Light

Rapid 45°C

Delay

Lightly soiled crockery, with no dried-on

food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

Half Load

Normally soiled crockery.

Standard program, the most efficient

in terms of its combined energy and water

consumption.

X 11.0 0.92 240 Full

Fast Daily 60°C

Delay

Half Load

Normally soiled crockery. X 11.0 1.30 80-95 Full

Steam

Delay

Program including steam action dedicated

for heavily soiled crockery, pots and pans.

Soaking or hand pretreatment is no longer

needed.

X 14.5 1.75 180-190 Full

Hygiene

Delay

Normally or heavily soiled crockery, with

additional antibacterial wash. Program

interruption (e.g. due to door opening) can

compromise elimination of germs.

X 14.0 1.40 110-120 Full

5019 300 01577

Options and display description

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE

CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER

30 SECONDS IF NO CYCLE HAS STARTED.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

SALT INDICATOR

When lit (at the end of the cycle), the

salt reservoir needs to be refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle), the

rinse aid dispenser needs to be

refilled.

HALF LOAD BUTTON

Half load cycle can be used

for the upper or lower rack.

Select the required program

then press the “Half Load”

button - the light comes on.

Turns off at the end of the

program.

The “Half Load” option can

be used with the programs

indicated in the table of

programs.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program.

Adjustable from 1 to 24

hours.

With each press of the

button, the delayed start

indicator increases by one

hour and after 24 restarts

from 0.

Then press the START

button.

The dishwasher will start

after the set time.

TABLET SETTING

This setting allows to

optimize the cycle

performances according the

type of detergent used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control panel

has to be off.

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 01577

EN -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rackCLICK!HGD - OPENLOWER RACK - depending on the modelB - Cutlery basket: can be

Page 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A