Whirlpool ADG 8000 FD Instruction for Use download pdf

EN -1-

Whirlpool is a registered trademark of Whirlpool USA

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required program lights

up (see “Table of programs”

below).

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute.

If pressed when the dishwasher is switched off it

drains any possible liquids from dishwasher

(1 minute process).

If the indicator flashes repeatedly, see page 6 -

chapter ”What to do if...”.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program. When the door is opened during a

washing cycle, the cycle is temporarily paused: the

Start indicator blinks.

To resume the cycle push the Start button and

close the door within 3 seconds.

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may

vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic

calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.01 14-16 NO

Rapid 45°C

Delay

Lightly soiled crockery, with no dried-

on food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

Half Load

Normally soiled crockery.

Energy-saving program.

X 12.0 1.03 170 Full

Hygiene+

Delay

Normally or heavily soiled crockery, with

additional antibacterial wash. Program

interruption (e.g. due to door opening)

can compromise elimination of germs.

X 14.0 1.40 110-120 Full

Intensive 65°C

Delay

Recommended program for heavily

soiled crockery, especially suitable for

pans and saucepans.

X 15.0 1.60 165-175 Full

5019 300 00663

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir

needs to be refilled.

DELAYED START

BUTTON

The wash cycle can be

programmed to start

after 2, 4 or 8 hours.

Then press the Start

button. The wash

program will start after

the set time.

RINSE AID INDICATOR

When lit (at the end of the

cycle), the rinse aid

dispenser needs to be

refilled.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

TABLET SETTING

This setting allows to optimize the cycle performances

according the type of detergent used.

Push the Tablet button for 3 seconds (until the indicator

lights up) if you are using the combined detergents in

tablet (rinse aid, salt and deteregent in 1 dose).

If you are using powder detergent or liquid detergent,

the Tablet indicator on the control panel has to be off.

HALF LOAD BUTTON

Half load cycle can be used

for the upper or lower rack.

Select the required program

then press the “Half Load”

button - the light comes on.

Turns off at the end of the

program. The “Half Load”

option can be used with the

programs indicated in the

table of programs.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 00663

EN -1-Whirlpool is a registered trademark of Whirlpool USAChart(see at right for options description)PROGRAM SELECTION BUTTONPush “Programs” button (r

Page 2 - Daily check

EN -2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load the racks

EN -4-How to load the racksD - OPENLOWER RACK - depending on the model4A - Adjustable flaps (2 or 4): in horizontal position for cups / long utensils

Page 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A