Whirlpool ADG 8240 IX Instruction for Use download pdf

EN -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions. Differences of up

to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test

and other tests, contact the following address: “contact@whirlpool.com”.

* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Auto 40°-70°C

Delay

Multizone

Recommended program for routine

washes, with dried-on food.

X 7-15 1.00-1.70 70-172 Full

Pre-Wash cold

Delay

Multizone

Crockery to be washed later.

— 4.0 0.01 14-16 NO

Fragile 40°C

Delay

Multizone

Light soiling, for example glasses and

cups.

X 10.5 0.85 105-114 Light

Rapid 45°C

Delay

Multizone

Lightly soiled crockery, with no dried-on

food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

Multizone

Normally soiled crockery.

Standard program the most efficient in

terms of its combined energy and water

consumption.

X 11.0 1.03 170 Full

Fast Daily 60°C

Delay

Multizone

Normally soiled crockery.

X 11.0 1.30 80-95 Full

Intensive 65°C

Delay

Multizone

Recommended program for heavily

soiled crockery, especially suitable for

pans and saucepans.

X 15.0 1.60 165-175 Full

Hygiene

Delay

Multizone

Normally or heavily soiled crockery, with

additional antibacterial wash. Program

interruption (e.g. due to door opening) can

compromise elimination of germs.

X 14.0 1.40 110-120 Full

5019 300 01092

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

MULTIZONE

Allows you to choose the washing

zones. Press this button (repeatedly)

to select the wash zones:

both racks

only lower rack

only upper rack

- indicator lits

TABLET SETTING

This setting allows to optimize the cycle performances according

the type of detergent used. Push the Tablet button for 3 seconds

(until the indicator lights up) if you are using the combined

detergents in tablet (rinse aid, salt and detergent in 1 dose). If you

are using powder detergent or liquid detergent, the Tablet indicator

on the control panel has to be off.

DELAYED START BUTTON

Push the button (repeatedly) to

delay the start of the program.

Adjustable from 1 to 24 hours.

With each press of the button,

the delayed start indicator

increases by one hour and after

24 restarts from 0. Then press

the START button. The

dishwasher will start after the

set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 01092

EN -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksD - OPENLOWER RACK - depending on the model4A - Adjustable flaps (2 or 4): in horizontal position for cups / long utensils

Page 5 - Maintenance and care

EN -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A