Whirlpool ADP 7652 A+ PC 6S SL Instruction for Use download pdf

GB -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on

conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40°-70°C

Delay

Power Clean

Recommended program for routine

washes, with dried-on food (e.g. EN

50242).

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay

Crockery to be washed later.

— 4.0 0.03 14 NO

Fragile 40°C

Delay

Light soiling, for example glasses and

cups.

X 10.0 0.85 100 Light

Rapid 45°C

Delay

Lightly soiled crockery, with no dried-

on food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Power Clean

Normally soiled crockery.

Energy-saving program.

X 12.0 1.03 150 Full

Fast Daily 60°C

Delay

Normally soiled crockery.

X 10.0 1.30 80 Full

Half Load 50°C

Delay

Ideal for washing a half load of lightly or

normally soiled crockery.

X 7.5 1.00 80 Full

Intensive 65°C

Delay

Power Clean

Recommended program for heavily

soiled crockery, especially suitable for

pans and saucepans.

X 14.0 1.60 145 Full

5019 396 03648

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of detergent

used. Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in tablet

(rinse aid, salt and detergent in

1 dose). If you are using powder

detergent or liquid detergent,

the Tablet indicator on the

control panel has to be off.

DELAYED START BUTTON

Push the button (repeatedly) to

delay the start of the program -

delay indicator turns on.

Adjustable from 1 to 24 hours.

With each press of the button,

the delayed increases by one

hour and after “h 24” returns to

“h 00”. When this option is

selected the delay indicator

turns on. Then press the START

button. The dishwasher will

start after the set time.

POWER CLEAN

Thanks to the additional

power jets this option

provides a more intensive and

powerful wash in the lower

rack, in the specific area.

This option is recommended

for washing pots and

casseroles (see page 4).

Press this button to activate

Power Clean (the indicator

lights up).

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 03648

GB -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Page 2 - Daily check

GB -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to use Power Clean

GB -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Page 5 - Maintenance and care

GB -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A