Whirlpool ADP 8673 A+ PC 6S IX Instruction for Use download pdf

GB -1-

Chart

(see at right for options description)

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions.

Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

6th Sense

Power Clean

40-70°C

Delay

Power Clean

Multizone

Use for normal soiled dishes with dried-on food.

Senses the level of soiling on the dishes

and adjusts the program accordingly.

When the sensor is detecting the soil level an

animation appears in the display and the cycle

duration is updated. The Power Clean

option is activated automatically with this

program. To deactivate, press the Power Clean

button on the control panel.

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14 NO

Fragile 40°C

Delay

Multizone

Light soiling, for example glasses and cups. X 10.0 0.85 100 Light

Rapid 45°C

Delay

Multizone

Lightly soiled crockery, with no dried-on food. X 11.0 0.80 30 NO

Eco

50°C

Delay

Power Clean

Multizone

Normally soiled crockery.

Energy-saving program.

X 11.0 1.05 195 Full

Fast Daily 60°C

Delay

Multizone

Normally soiled crockery. X 10.0 1.30 80 Full

Steam

Delay

Power Clean

Multizone

Program including steam action dedicated for

heavily soiled crockery, pots and pans. Soaking or

hand pretreatment is no longer needed.

X 14.0 1.70 180 Full

Hygiene

Delay

Power Clean

Multizone

Normally or heavily soiled crockery, with additional

antibacterial wash. Program interruption (e.g. due

to door opening) can compromise elimination of

germs.

X 13.0 1.50 118 Full

5019 396 03660

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used. Push the Tablet

button for 3 seconds

(until the indicator lights

up) if you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

MULTIZONE

Allows you to choose the

washing zones. Press this button

(repeatedly) to select the wash

zones:

both racks

only lower rack

only upper rack

- indicator lits

POWER CLEAN

Thanks to the additional power jets this

option provides a more intensive and

powerful wash in the lower rack, in the

specific area. This option is recommended

for washing pots and casseroles (see page

4). Press this button to activate Power

Clean (the indicator lights up). For non

Power Clean loading to achieve best

cleaning performances and resources

optimization, Power Clean should be

switched off.

DELAYED START

BUTTON

Push the button

(repeatedly) to delay

the start of the

program. Adjustable

from 1 to 24 hours.

With each press of the

button, the delayed

start indicator

increases by one hour

and after 24 restarts

from 0. Then press the

START button. The

dishwasher will start

after the set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 03660

GB -1-Chart(see at right for options description)START/RESUME BUTTONPush this button to start the selected program: the indicator lights up and goes o

Page 2 - Daily check

GB -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to use Power Clean

GB -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Page 5 - Maintenance and care

GB -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A