Whirlpool ADP 8673 A+ PC 6S WH Instruction for Use download pdf

GB -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions. Differences of up

to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test

and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

6th Sense

Power Clean

40°-70°C

Delay

Power

Clean

Use for normal soiled dishes with dried-

on food. Senses the level of soiling on the

dishes and adjusts the program

accordingly. When the sensor is detecting

the soil level an animation appears in the

display and the cycle duration is updated.

The Power Clean option is activated

automatically with this program. To

deactivate, press the Power Clean button

on the control panel.

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.03 14 NO

Fragile 40°C

Delay Light soiling, for example glasses and cups. X 10.0 0.85 100 Light

Rapid 45°C

Delay

Lightly soiled crockery, with no dried-on

food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Power

Clean

Normally soiled crockery.

Energy-saving program.

X 11.0 1.03 170 Full

Fast Daily 60°C

Delay Normally soiled crockery. X 10.0 1.30 80 Full

Silent 50°C

Delay

Normally soiled crockery, gentle and

quiet thanks to the lower spray pressure

(39 dBa).

X 13.0 1.20 290 Light

Dual Wash

Delay

Power

Clean

This program is able to manage different

wash intensity for each rack. You can

optimize loading and properly wash

different crockery in one cycle, loading

delicate items in upper rack and pots and

pans in lower rack.

X 15.0 1.35 155 Full

5019 396 03740

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of detergent

used. Push the Tablet button

for 3 seconds (until the

indicator lights up) if you are

using the combined detergents

in tablet (rinse aid, salt and

detergent in 1 dose). If you are

using powder detergent or

liquid detergent, the Tablet

indicator on the control panel

has to be off.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program. Adjustable from

1 to 24 hours. With each press

of the button, the delayed start

indicator increases by one

hour and after 24 restarts

from 0. Then press the START

button. The dishwasher will

start after the set time.

POWER CLEAN

Thanks to the additional

power jets this option

provides a more intensive

and powerful wash in the

lower rack, in the specific

area.

This option is recommended

for washing pots and

casseroles (see page 4).

Press this button to activate

Power Clean (the indicator

lights up).

For non Power Clean loading

to achieve best cleaning

performances and resources

optimization, Power Clean

should be switched off.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 03740

GB -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Page 2 - Daily check

GB -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to use Power Clean

GB -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Page 5 - Maintenance and care

GB -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A