GB -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions.
Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test
and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.
A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product conditions.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor 40-70°C
Delay
Multizone
Antibacterial
rinse
Recommended program for routine
washes, with dried-on food
(e.g. EN 50242).
X 7-14 1.00-1.65 80-165 Full
P2
Pre-wash cold
Delay
Multizone
Crockery to be washed later. - 4.0 0.03 14 NO
P3
Glass 40°C
Delay
Multizone
Light soiling, for example glasses and cups. X 10.0 0.85 100 Light
P4
Express 45°C
Delay
Multizone
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.80 30 NO
P5
Eco
2)
50°C
Delay
Multizone
Antibacterial
rinse
Normally soiled crockery.
Energy-saving program.
X 7.0 0.92 245 Full
P6
Normal 60°C
Delay
Multizone
Antibacterial
rinse
Normally soiled crockery. X 10.0 1.30 80 Full
P7
Night 39 dBA 50°C
Delay
Multizone
Normally soiled crockery, gentle and quiet
thanks to the lower spray pressure (39
dbA).
X 10.0 1.20 290 Light
P8
All in 1
Delay
Multizone
Antibacterial
rinse
This program is able to manage different
wash intensity for each rack. You can
optimize loading and properly wash
different crockery in one cycle, loading
delicate items in upper rack and pots and
pans in lower rack.
X 11.0 1.35 155 Full
5019 496 01760
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds
(until the indicator lights
up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after
24 restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
ANTIBACTERIAL RINSE
3)
This function activates an
antibacterial rinse at the end of the
wash cycle, guaranteeing a further
reduction of bacteria. Press the
button to activate or deactivate the
function. This function can be used
with the programs indicated in the
table of programs. The dishwasher
door must be kept shut for the entire
duration of the program in order to
guarantee reduction of bacteria.
If the door is opened the indicator
lamp starts flashing.
Quick reference guide
(8 pages)
(8 pages)
(64 pages)
(8 pages)
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals