Whirlpool GSX 5520/1 Instruction for Use download pdf

Before using the dishwasher, read the

installation and maintenance instructions carefully!

5019 496 01103

GSX 5520

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on the

EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on. Standard NF EN 13697 - November 2001.

1. OVERVIEW

On button

Off button

Delayed start button

Press the button repeatedly to delay the

start of the programme by 3, 6 or 9 hours.

Then press the START button. The

dishwasher will start at the set time.

Detergent setting upon initial use and when using a different type of detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

“3h” = 2in1, “6h” = 3in1, “9h” = other combined action detergents

(in this way, the rinse aid and/or salt indicator is deactivated). All 3

LEDs light up = Powder detergent (factory setting).

4. Switch the appliance off and then switch it on again. The selected

detergent type will be indicated on the display by the

corresponding LEDs for approx. 3 seconds.

Programme selection button

Press the button repeatedly until the desired programme

indicator lights up.

START

button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

START

button reset function:

Press this button for at least 2 seconds; the selected

programme and options are cancelled. Main failure

displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions

are given in chapter “What to do if...”.

An acoustic signal continues to sound as long as the error

persists.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or salt

need to be added.

Add just before starting a wash cycle.

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Available

options

Description of programme large small Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. — — 4.0 0.03 14 ±

Quickwash 40°C

Lightly soiled crockery, with no dried-

on food.

X — 10.0 0.65 30 ±

Bio

50°C

Normally soiled crockery.

Energy Saving Programme.

X X 12.0 1.05 165 ±

Hygienic +

Normally or heavily soiled crockery,

with additional antibacterial wash.

Programme interruption (e.g. due to

door opening) can compromise

elimination of germs.

X X 13.0 1.50 115 ±

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 14.0 1.55 155 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

1GBBefore using the dishwasher, read the installation and maintenance instructions carefully!5019 496 01103GSX 55201) Programme data obtained in confo

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on modelLong-handled utensils (kitchen knives) must be arranged with the sharp

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l