Whirlpool GSXP 300 POWER Instruction for Use download pdf

Before using the dishwasher, read the

installation and maintenance instructions carefully!

5019 496 01089

GSXP 300 POWER

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on the

EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with Standard NF

EN 13697 - November 2001.

ON button

OFF button

Programme selection button

Press button P (repeatedly) until the required

programme number appears on the display.

Fault indication and wash time display

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

In the presence of a fault indication “F..” –, consult the

section “5. What to do if …”.

The acoustic signal continues to sound as long as the

error persists.

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Set the detergent

Press button P (repeatedly) to set the type of detergent used.

This deactivates the rinse aid and/or salt indicator.

Half Load/Multizone button

Load the top

bottom

rack

only.

Press once = wash

top rack

(the indicator/symbol lights up)

Press twice = wash

bottom rack

(the indicator/symbol

lights up)

Press 3 times =

Off

(Half load/Multizone deactivated).

When washing without the top rack, press the “Half

load” (i.e. “wash bottom rack”) button. “twice (the

corresponding indicator/symbol lights up).

Powder, gel, tablets (standard): indicator off

Detergent with rinse aid: left indicator

Detergent with salt + rinse aid: right indicator

Power Clean

High pressure with an additional jet for better washing

results and greater bottom rack load flexibility.

“Delayed start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each

press of the button, the delayed start indicator increases

by one hour and after 24 restarts from 00. Then press

the START button. The dishwasher will start after the set

time.

START button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

RESET button - for programme change or indication of

faults

Press this button to cancel a started programme and

selected extra functions. Press this button to cancel the

main fault indicators (F..); also refer to the section “5.

What to do, in case of...”. The programme can then be

selected and started.

Running programme indicator

A LED light projected on the floor indicates that the

dishwasher is working.

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Selectable

extra

functions

Loading instructions large small Litres kWh Minutes

40-70°C

Normally or heavily soiled crockery, including

pots and pans.

X X 7-17 0.99-1.75 65-220 ±

Pre-Rinse cold

Crockery to be washed later.

— — 4.0 0.03 14 ±

Handwashing 40°C

Lightly soiled crockery, e.g. glasses and cups,

with low spray pressure.

X — 10.0 0.85 125 ±

Quickwash 40°C

Lightly soiled crockery, without dry residuals.

X — 10.0 0.65 30 ±

Bio Normal

50°C

Normally soiled crockery. Energy-saving

programme.

X X 11.0 0.98 170 ±

Hygienic +

Normally or heavily soiled crockery, with

additional antibacterial action. An interruption

of the programme (e.g. due to door opening)

can compromise elimination of germs.

X X 13.0 1.50 115 ±

Overnight 55°C

Normally soiled crockery, gentle and quiet (39

dbA) thanks to the lower pressure jet.

X X 13.0 1.20 290 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - GSXP 300 POWER

1GBBefore using the dishwasher, read the installation and maintenance instructions carefully!5019 496 01089GSXP 300 POWER1) Programme data obtained in

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSCUTLERY RACK:May be used in two different positions.In position 2 the upper rack must be lowered (see

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l