Whirlpool GSXP 70/2 POWER Instruction for Use download pdf

Before using the dishwasher, read the

installation and maintenance instructions carefully!

GSXP 70 POWER

5019 496 01108

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads,

extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on the

EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on Standard NF EN 13697 - November 2001.

ON button

OFF button

Programme selection button

Press button P (repeatedly) until the required programme

number appears on the display.

Fault indication and wash time display

In normal operation it indicates the remaining time (h:mm),

whereas with “Delayed start” selected it indicates the time

remaining until programme start (hh).

In the presence of a fault indication “F..” –, consult the section

“5. What to do if…”.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or salt need to

be added.

Add just before starting a wash cycle.

Set the detergent

Press button P (repeatedly) to set the type of detergent used.

This deactivates the rinse aid and/or salt indicator.

“Half Load”/“Multizone”

Load the upper

lower rack

only

Press once = wash

upper rack

(the indicator/symbol lights up)

Press twice = wash

lower

rack

(the indicator/symbol lights up)

Press 3 times =

Off

(“Half load”/“Multizone” deactivated).

When washing without the top rack, press the “Half load” (i.e.

“wash bottom rack”) button twice; the indicator /corresponding

symbol lights up.

Powder, gel, tablets (standard): indicator off

Detergent with rinse aid: left indicator

Detergent with salt + rinse aid: right indicator

Power Clean

High pressure with an additional jet for better washing results

and greater bottom rack load flexibility.

“Delayed Start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each press

of the button, the delayed start indicator increases by one

hour and after 24 restarts from 00. Then press the START

button. The dishwasher will start after the set time.

START button

The indicator lights up during operation, flashes when a fault

occurs, and goes off at the end of the programme.

RESET button - for programme change or indication of faults

Press this button to cancel a started programme and selected

extra functions. Press this button to cancel the main fault

indicators (F..); also refer to the section “5. What to do if…”.

The programme can then be selected and started.

Running programme indicator

A LED light projected on the floor indicates that the

dishwasher is working.

Table 1.1.

Programme chart

Detergent

dispenser

Consumption

Programmes

Available

options

Loading instructions large small Litres kWh Minutes

Sensor + 40-70°C

Normally or heavily soiled

crockery, including pots and pans.

X X 7-17 0.99-1.58 65-170 ±

Pre-Rinse cold

Crockery to be washed later. — — 4.0 0.03 14 ±

Hand washing 40°C

Light soiling, e.g. glasses and cups,

with a lower pressure jet.

X — 10.0 0.85 125 ±

Quickwash 40°C

Lightly soiled crockery, with no

dried-on food.

X — 10.0 0.65 30 ±

Eco

50°C

Normally soiled crockery. Energy

Saving Programme.

X X 11.0 1.05 170 ±

Hygienic +

Normally or heavily soiled crockery,

with additional antibacterial wash.

Programme interruption (e.g. due to

door opening) can compromise

elimination of germs.

X X 13.0 1.50 115 ±

Overnight 55°C

Normally soiled crockery, gentle

and quiet (39 dbA) thanks to the

lower pressure jet.

X X 13.0 1.20 290 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 496 01108

1GBBefore using the dishwasher, read the installation and maintenance instructions carefully!GSXP 70 POWER5019 496 011081) Programme data obtained in

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSCUTLERY RACK:May be used in two different positions.In position 2 the upper rack must be lowered (see

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l