Whirlpool MJD 9000 IN Instruction for Use download pdf

//2/G

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Press the

/ OFF button.

(The first time you use the appliance

and when using a different type of

detergent)

1. Select the third programme from the

top in the relative table.

2. Press the Start button for about 7

seconds until the display changes.

3. Select the required detergent with

the Start button (OFF = powder

detergent, 2 in 1, 3 in 1, 4 in 1) (shown on the display).

4. Switch the appliance off and then switch it on again. The selected

detergent type will be shown on the display for approximately 3

seconds after switching on.

For dosage of powder detergent in compartment

and

refer to the

programmes table.

Mechanical indicator

Electric indicator on control panel (if provided).

On models with water softener

system only.

Mechanical indicator

. Electric

indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Select the desired programme (using the specific button or knob).

The corresponding indicator lamp lights up.

If necessary (and if provided).

The corresponding indicator lamp lights up.

The selected programme is

then memorised (even in the

event of power failure).

- Only open the dishwasher if necessary

(Warning: beware of hot steam).

- If the appliance is switched off during a

wash cycle, when switched on again it

will resume the cycle from where it was

interrupted.

Only after the START button has switched off: Press the ON /

OFF

button.

All the indicator lamps switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

Switch on the appliance

Select, save, and

supply the detergent

ABC

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Select additional options

Press the Start button

“Change programme in progress”

Press the START button for 2 sec. until the

Start indicator lamp switches off.

Select another programme and press the

START button again.

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

1 2 3 4

Summary of Contents

Page 1 - How to use the appliance

//2/GHow to use the applianceFurther indications are given in the single chapters and in the user instructions.Press the ON / OFF button.(The first ti

Page 2

Dishwasher loading instructions and racks provideddepending on the modelUpper rack:Crockery holder (A):Depending on the position, for long-handles ute

Page 3 - What to do if

What to do if...If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the

Page 4 - Quick Reference Guide

5019 996 01504GBMJD 9000Quick Reference GuideBefore using the dishwasher, read the user instructions!MAY/I/B/GB(We reserve the right to make technical