Whirlpool PDSX 6232 A++ Instruction for Use download pdf

EN -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle, the

cycle is temporarily paused: the Start indicator blinks.

To resume the cycle push Start button and close

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and

may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic

calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact (only in English) using the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

* Power consumption: Left-on mode: less than 1.27 W. Off mode: less then 0.40 W.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Auto 40°-70°C

Delay

Antibacterial

rinse

Recommended program for

routine washes, with dried-on

food (e.g. EN 50242).

X 7-15 1.00-1.70 70-172 Full

Vorspülen cold

Delay Crockery to be washed later. – 4.0 0.01 14-16 NO

Express 45°C

Delay

Lightly soiled crockery, with no

dried-on food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

Antibacterial

rinse

Normally soiled crockery.

Standard Program, the most

efficient in terms of its

combinated energy and water

consumption

X 11.0 0.92 240 Full

Standard 60°C

Delay

Antibacterial

rinse

Normally to heavily soiled

crockery.

X 11.0 1.30 80-95 Full

Steam

Delay

Antibacterial

rinse

Program including steam action

dedicated for heavily soiled

crockery, pots and pans.

Soaking or hand pretreatment is

no longer needed.

X 14.5 1.75 180-190 Full

5019 600 00138

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ

THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING

ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING

THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30

SECONDS IF NO CYCLE HAS STARTED.

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program.

Adjustable from 1 to 24 hours.

With each press of the button,

the delayed start indicator

increases by one hour and

after 24 restarts from 0.

Then press the START button.

The dishwasher will start after

the set time.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

ANTIBACTERIAL RINSE

This function activates an

antibacterial rinse at the end of

the wash cycle, guaranteeing a

further reduction of bacteria.

Press the button to activate or

deactivate the function.

This function can be used with

the programs indicated in the

table of programs.

The dishwasher door must be

kept shut for the entire duration

of the program in order to

guarantee reduction of bacteria.

If the door is opened the

indicator lamp starts flashing.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of detergent

used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in tablet

(rinse aid, salt and detergent in

1 dose).

If you are using powder

detergent or liquid detergent,

the Tablet indicator on the

control panel has to be off.

Quick reference guide

Privileg is a registered trade mark

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 600 00138

EN -1- Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksACLICK!Rotate the flapclockwise andhook on rackRotate the flap clockwise and hook on rackCLICK!HGD - OPENLOWER RACK - depen

Page 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A