Whirlpool WP 76/3 Instruction for Use download pdf

EN -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle, the

cycle is temporarily paused: the Start indicator blinks.

To resume the cycle push Start button and close

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may

vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic

calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard

loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40-70°C

Delay

Antibacterial

rinse

Recommended program for routine

washes, with dried-on food (e.g. EN

50242).

X 7-14 1.00-1.60 70-155 Full

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.03 14 NO

Fragile 40°C

Delay

Light soiling, for example glasses

and cups.

X 10.0 0.85 100 Light

Rapid 45°C

Delay

Lightly soiled crockery, with no

dried-on food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Power Clean

Normally soiled crockery.

Energy-saving program.

X 11.5 1.03 170 Full

Fast Daily 60°C

Delay Normally soiled crockery. X 10.0 1.30 80 Full

Half Load 50°C

Delay

Ideal for washing a half load of lightly

or normally soiled crockery.

X 7.5 1.00 80 Full

Intensive 65°C

Delay

Power Clean

Recommended program for heavily

soiled crockery, especially suitable

for pans and saucepans.

X 14.0 1.60 145 Full

5019 300 02270

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

POWER CLEAN

Thanks to the additional power jets this option provides a more

intensive and powerful wash in the lower rack, in the specific

area. This option is recommended for washing pots and

casseroles (see page 4). Press this button to activate Power

Clean (the indicator lights up).

TABLET SETTING

This setting allows to

optimize the cycle

performances according the

type of detergent used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program. - delay indicator

turns on.

Adjustable from 1 to 24 hours.

With each press of the button,

the delayed increases by one

hour and after “h 24” returns

to “h 00”.

When this option is selected

the delay indicator turns on.

Then press the START button.

The dishwasher will start after

the set time.

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 02270

EN -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to use Power Clean

EN -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Page 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...have deposits: regeneration salt residue - Water too hard. - In areas

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A