Whirlpool CAE2743BQ Specifications download pdf (Page 9)

CONNECT DRAIN HOSE

Proper routing of the drain hose avoids damage to your floor

due to water leakage.

Remove drain hose from the washer drum

1. Remove tape from the washer drain port on the back of

the washer.

2. If clamp is not already in place on elbow end of drain hose,

slide it over end as shown.

3. Squeeze clamp with pliers and slide elbow end of drain

hose onto washer drain port and secure with clamp.

4. The washer drain system can be installed using a floor drain,

wall standpipe, floor standpipe, or laundry tub.

5. Place hose into standpipe (shown in picture) or over side

of laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay

on bottom of laundry tub. Drain hose form must be used.

Drain

hose form

6. For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and Parts."

7. The floor drain system requires a siphon break that may be

purchased separately. The siphon break (Part Number 285834)

must be a minimum of 28" (710 mm) from the bottom of the

washer. Additional hoses might be needed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Whirlpool CAE2743BQ Specifications Page 9