Whirlpool SH09PGWAX Instruction for Use download pdf (Page 4)

N.B.: An insulating wooden panel should be fitted

beneath the hob, positioned at a minimum of 20 mm

from the hob underside. This wooden panel must be

removable in order to allow for any maintenance

operations beneath the hob.

X mm

Fig.5

3- Sit-on hobs (Class 1) with edges higher than 58 mm

(see figure 2, detail H3). In this case, the lower

casing of the hob does not protrude further than the

edge of the appliance. Even when the hob is resting

on the worktop, it will suffice to leave space for the

gas supply tube and electricity supply cable. To fit

this type of hob, follow the instructions below (fig. 5):

• Fix the two screws provided "A" at a distance from

the back panel as shown in figure 5, leaving the

heads of the screws sticking out of the wood by 1.5

mm.

• Hook the hob onto the two screws "A" and push it

towards the back.

• Fix the appliance to the cabinet at the rear, using the

two brackets "B" and the four screws "C" (these are

all provided).

N.B.: to make maintenance operations more efficient,

the area around the hob must be easily accessible after

it has been installed (i.e. there are no completely shut-

off elements).

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Whirlpool SH09PGWAX Instruction for Use Page 4