Whirlpool Duet W10049540 User Manual download pdf (Page 5)

Door Reversal Kit

Are you planning to reverse the door swing direction on your

DUET

dryer? To do so, you will need to purchase a Door

Reversal Kit.

To order, call the dealer from whom you purchased your dryer or

refer to the “Assistance or Service” section of this manual. Ask

for Part Number 8530069 (Shield Blue), 8530070 (Shield

Platinum), 8530071 (Biscuit), 8530072 (Pewter) or 8579123

(Diamond Dust [Silver]).

Door Reversal and Stack Combination Kit

Are you planning to reverse the door swing direction on your

DUET

dryer and stack your DUET

washer and dryer? To do so,

you can purchase a Door Reversal and Stack Combination Kit.

To order, call the dealer from whom you purchased your dryer or

refer to the “Assistance or Service” section of this manual. Ask

for Part Number 8530073 (Shield Blue), 8530074 (Shield

Platinum), 8530075 (Biscuit), 8530076 (Pewter) or W10057200

(Diamond Dust [Silver]).

Backguard

If you are installing your DUET

washer and dryer and wish to

avoid having loose items fall behind your machines, you may

purchase a pair of washer/dryer backguards. These will reduce

the chance of items falling behind the machines during operation.

To order, call the dealer from whom you purchased your dryer or

refer to the “Assistance or Service” section of this manual. Ask

for Part Number 8558694 (White), 8558695 (Biscuit), 8558696

(Pewter), or W10057220 (Diamond Dust [Silver]).

Location Requirements

You will need

■ A location that allows for proper exhaust installation. See

“Venting Requirements.”

■ A separate 30-amp circuit.

■ If you are using a power supply cord, a grounded electrical

outlet located within 2 ft (61 cm) of either side of the dryer.

See “Electrical Requirements.”

■ A sturdy floor to support the total dryer weight of 200 lbs

(90.7 kg). The combined weight of a companion appliance

should also be considered.

■ A level floor with a maximum slope of 1" (2.5 cm) under entire

dryer. If slope is greater than 1" (2.5 cm), install Extended

Dryer Feet Kit, Part Number 279810. Clothes may not tumble

properly and automatic sensor cycles may not operate

correctly if dryer is not level.

■ For a garage installation, you will need to place the dryer at

least 18" (46 cm) above the floor. If you are using a 10"

(25.4 cm) pedestal, you will need to place the pedestal at

least 9" (22.9 cm) above the floor. With a 13" (33 cm)

pedestal, you will need to place the pedestal at least

6" (15.2 cm) above the floor. With a 15.5" (39.4 cm) pedestal,

you will need to place the pedestal at least 3.5" (8.9 cm)

above the floor.

Do not operate your dryer at temperatures below 45ºF (7ºC). At

lower temperatures, the dryer might not shut off at the end of an

automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will

be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,

installation of the dryer in garages, closets, mobile homes or

sleeping quarters. Contact your local building inspector.

Installation clearances

The location must be large enough to allow the dryer door to

open fully.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Whirlpool Duet W10049540 User Manual Page 5

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool Duet W10049540