Whirlpool WED9500TU1 Troubleshooting Guide download pdf (Page 10)

FOR SERVICE TECHNICIAN’S USE ONLY PART NO. W10177456A

TECH SHEET - DO NOT DISCARD PAGE 10

2. Slide the bracket over the top of the drum to

access the machine control electronics

connectors and mounting screw. See figure 17.

3. Remove all the wire connections to the

machine control electronics. See figure 18.

4. Remove the screw holding the machine control

electronics assembly to the mounting bracket.

See figure 17.

5. There are two plastic legs on the front of the

machine control electronics that slide under the

mounting bracket.

✔

There is one plastic leg on the rear of the

machine control electronics that slides

under the mounting bracket.

✔

There is a locking tab on the bottom of the

machine control electronics that snaps into

the mounting bracket.

Press the locking tab on the bottom of the

machine control electronics and slide the

assembly to the front, then lift.

3. Gently remove the decorative trim that

surrounds the door and upper console by

unsnapping it from the machine. See figure 20.

4. Slide the console up and off of the machine.

See figure 19.

5. The console mounting bracket is fastened to

the console front panel with two latches at both

sides of the console assembly. Unlatch the

bracket gently with a screwdriver while pulling

the mounting bracket assembly out. See

figure 19.

6. The console electronics is split into two

assemblies connected by two cables. Each

assembly is fastened to the decorative piece by

four plastic latches. To remove these

assemblies, gently compress the plastic

latches while pulling up on the assembly. For

the cycle selector assembly, the cycle selector

knob must first be removed by firmly pulling on

it or gently prying it straight upward. See

figure 21, page 11.

Console Electronics and Housing

Assembly

The console panel must be removed to access the

console electronics and housing assembly.

1. Perform steps 1 and 2 under Accessing &

Removing the Electronic Assemblies, page 9,

and disconnect the P2 and P5 harnesses from

the machine control.

2. Remove the screw that fastens the assembly to

the machine control mounting bracket (figure

17), and the two screws that fasten the

console assembly to the machine (figure 19).

P9

1

5

1

P14

P2

3

1

1

6

1

1

8

3

P5

P3

1

P13

1

P/N XXXXXX Rev X

Date Code YDDD-xx

XXXX-XXX

MADE IN COO

N.O.

Black

COM

Red

Heater

Relay 1

Motor

Relay

Tan

Black-White

White

Green-Yellow

Brown

Lt. Blue

Black

Yellow-Red

Open (Gas)

Black (Gas)

Red-White (Gas)

P4

N.O.

Blue

Water Valve

Relay

COM

Red

P8

Figure 18. Machine control electronics.

Figure 20. Remove the decorative trim.

Machine Control Electronics

Bracket Screws

FRONT

Machine Control

Electronics Mounting Screw

Figure 17. Remove machine control electronics

from mounting bracket.

Figure 19. Remove the console panel to access

the console electronics and housing assembly.

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments