Whirlpool ET14JK Specifications download pdf (Page 10)

Attaching the ice maker to a water supply

Read all directions carefully before you begin.

Electrical Shock Hazard

. Disconnect electrical supply to refrigerator

before installing.

Electrical drill must be grounded before drilling

holes in water line.

Failure to do so couki result in electriil shock,

serious injury, or death.

IMPORTANT:

Use copper tubing only and check for leaks.

Install ice maker tubing in areas where temperatures

are above freezing.

Tools required:

Standard screwdriver

7/is-inch and S-inch open-end wrenches or

2 adjustable wrenches

G-rch nut driver

Winch drill bit

Hand drill or electric drill (properly grounded)

NOTE: Your nearest appliance dealer has a kii

available with a X-inch saddle type shut-off valve, a

union, and copper tubing. Before purchasing, make

sure a saddle type valve complies with your local

plumbing codes. Do not use piercing type or %s-inch

saddle valve which reduces water flow and clogs

more easily.

Cold water supply

Ice maker water valve wntains a flow washer which is

used as a water pressure regulator. The ice maker

needs to be connected to a cold water line with water

pressure limitations of 20-120 psi. If a problem occurs,

call your utility company.

IMPORTANT:

. It may take up to 24 hours for your ice maker to

begin producing ice.

If operating the refrigerator before installing the water

connection, turn ice maker to the OFF position to

prevent operation without water.

All installations must be in accordance with local

plumbing code requirements.

INSTALLATiON IS NOT WARRANTED

BY REFRIGERATOR OR ICE MAKER

MANUFACTURER.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comments to this Manuals

No comments

Whirlpool ET14JK Specifications Page 10

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ET14JK