Whirlpool CATALYST Specifications download pdf (Page 20)

ACCESSING COMPONENTS IN THE CONSOLE

1. Disconnect the power supply to the washer.

2. Remove the two (2) Phillips Head screws

securing the lower left and right rear corners

of the console to the washer top. (Fig. 2)

3. Tilt the console back on the hinges that

secure the top of the console to the washer

back.

All components in the console are now accessible for service.

Fig. 2

RIBBON

CONNECTORS

SCREW

WIRING

HARNESS

CONNECTORS

WIRING

HARNESS

CONNECTOR

Fig. 3

IMPORTANT SERVICING POINTS

Electrostatic Discharge (ESD) Sensitive Electronics

Do not open the package containing the Electronic Printed Circuit Board until it is time to install it.

ESD may damage or weaken the electronic board.

•Use an anti-static wrist strap. Connect wrist strap to a green ground connection point or unpainted metal on the

appliance.

Touch your finger repeatedly to a green ground connection point or unpainted metal on the appliance.

•Avoid touching electronic parts or terminal contacts;

handle the electronic board by the edges only.

Removing the Electronic Control Board

The Electronic Control Board is located in the center of the console area.

1. Disconnect the four (4) wiring harness plugs and two (2) ribbon connectors from the electronic

control board. (Fig. 3)

2. Remove the hex-head screw securing the electronic control board to the control bracket.

SCREW

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Whirlpool CATALYST Specifications Page 20