Whirlpool HOB 280 AN Instruction for Use download pdf

HOB 280 PRODUCT DESCRIPTION SHEET

5019 619 01000/C

To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.

LIGHTING THE BURNERS

• To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting .

• Press the knob against the control panel to ignite the burner.

• After the burner has ignited, keep the knob pressed for about 10 seconds to allow the thermocouple to warm up.

This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden

draught, an interruption in the gas delivery, boiling over of liquids, etc.).

• The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not

remain lit, wait at least one minute before trying to light it again.

- The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough.

In this case, repeat the operations described above.

PRATICAL ADVICE FOR USING THE BURNERS

For better burner performance, please stick to the following

rules:

- Use pots and pans that fit the burners (see table on the

right).

- Only use flat-bottomed pots and pans.

- Use the correct amount of water for cooking foods and

keep the pot covered.

Due to continued product development, Whirlpool

reserves the right to change specifications or model

availability without notice.

Removable panstand grids

2-3.

Medium burners

Large burner

Small burner

Medium burner control knob

Large burner control knob

Small burner control knob

10.

Electric ignition button

SYMBOLS

Tap closed

Maximum flame

Minimum flame

Burner Pot Ø

Rapid

from 24 to 26 cm

semi-rapid

from 16 to 22 cm

auxiliary

from 8 to 14 cm

DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)

NOTE: In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct

distance.

ELECTRIC SUPPLY: 230 -240 V - 50 Hz

BURNER

NG ULPG

Pressure Injector Rate Pressure Injector Rate

(kPa) (mm) MJ/h (kPa) (mm) MJ/h

Front RHS (Auxiliary) 1.00 0.85 3.60 2.75 0.52 3.60

Rear RHS (Semi-rapid) 1.00 1.05 5.94 2.75 0.65 5.94

Rear LHS (Semi-rapid) 1.00 1.05 5.94 2.75 0.65 5.94

Front LHS (Rapid) 1.00 1.40 10.80 2.75 0.85 10.80

1 2 3 4

Summary of Contents

Page 1 - 5019 619 01000/C

HOB 280 PRODUCT DESCRIPTION SHEETGB 5019 619 01000/CTo get full satisfaction from the hob, please read these instructions carefully and keep them for

Page 2 - INSTALLATION

PRECAUTIONS AND GENERAL ADVICETo get full satisfaction from your hob, please read these instructions carefully and keep them for future consultation•

Page 3

INSTALLATIONGAS CONNECTION1.Check the “gas type” sticker attached to the hotplate. 2.This appliance shall be installed in accordance with installation

Page 4 - AFTER-SALES SERVICE

ADJUSTMENT TO DIFFERENT TYPES OF GASIf the appliance is intended to operate with a different gas from the gas type stated on the rating plate change t