Whirlpool Freezer EV150 User Manual download pdf (Page 2)

The kit contains the following:

4 each Nylon Ties

1 each Heat Shield

3 each Aluminum Pop-Rivets

1 each Instruction Sheet

The instructions listed below are more detailed than those

included in the Heat Shield Kit:

NOTE: To replace the heat shield, the evaporator mount-

ing plate must be removed.

1. Remove evaporator cover and ground wire.

2. To remove the evaporator mounting plate perform the

following steps.

a) Disconnect wiring to fan motor and defrost heat-

er and free wiring from retainer clips.

b) Remove defrost bi-metal and fan assembly from

evaporator mounting plate.

c) Remove thermostat sensor from the two retain-

ing clips.

d) Remove air blocks from both sides of the evapo-

rator.

NOTE: Do not discard these. They must

be reinstalled later.

e) Remove the two mounting screws securing the

evaporator to the mounting plate.

f) Remove evaporator mounting plate screws. Gen-

tly swing the left side of the evaporator out, and

carefully slide out the mounting plate. The glass

defrost heater is still mounted in the heat shield.

3) To replace the heat shield on the evaporator plate

perform the following steps:

CAUTION: Special care must be taken when han-

dling the glass defrost heater element.

l Hold the heater assembly by the insulated end

caps. Touching the glass with your fingers will

deposit salt on the glass and cause early failure.

l Be careful not to pull the end caps off the glass

tube. The end caps are not sealed to the glass

tube.

a) Cut the wire ties and carefully remove the heater

from the heat shield.

b) Using a side cutter cut the inside part of the (3)

pop rivets that secure the heat shield to the evap-

orator mounting plate. Remove and discard ex-

isting heat shield.

c) Flatten the bottom section of evaporator mount-

ing plate to at least ¼” from the back freezer wall.

See Figure 2.

d) Install the new heat shield using (3) aluminum

pop-rivets (included).

NOTE: If a pop rivet tool is

not available, small aluminum or stainless steel

screws (obtained locally) can be used. Do not

use steel screws. They will rust.

e) Re-install heater element into the new heat shield

using the (2) nylon ties.

4) Re-install evaporator mounting plate, evaporator,

components and wiring.

5) Re-install ground wire and evaporator cover.

6) Bend forward the bottom section of the evaporator

cover approximately 30° but not to protrude past unit

drain trough.

See Figure 2.

Heat Shield

Bend Forward

Flatten ¼” Max.

from Freezer Wall

Evaporator

Mounting Plate

Evaporator Cover

(

)

Pop Rivets

Side View

Bottom View

Evaporator

FIGURE 2FIGURE 2

FIGURE 2

— 2 —

1 2

Comments to this Manuals

No comments

Whirlpool Freezer EV150 User Manual Page 2

Comments to this Manuals