INSTALLATION INSTRUCTIONS24" (61.0 CM) GAS SINGLE AND DOUBLE BUILT-IN OVENBUILT-IN OVEN SAFETYIMPORTANT: Installer: Leave installation instructio
103. Flip the regulator pin over and snap pin firmly into place.4. Screw the hex-shaped regulator cap securely back into place. Do not overtighten.To
112. Unscrew the hex-shaped regulator cap from the regulator and remove the regulator pin.3. Flip the regulator pin over and snap pin firmly into plac
W10203509A© 2008. Whirlpool Corporation.All rights reserved.7/08Printed in U.S.A.
2WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
4Product Dimensions - Double OvenCabinet Dimensions - Double OvenDouble Oven Installed in CabinetNOTE: For gas supply pipe, provide a 3" x 3"
5 A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommen
6Gas Pressure RegulatorThe gas pressure regulator supplied with this oven must be used. The inlet pressure to the regulator should be as follows for p
73. Use a ¹⁵⁄₁₆" combination wrench and an adjustable wrench to attach the flexible connector to the adapters. Check that connector is not kinked
83. Securely fasten oven to cabinet using the 0.188 x 2.1" screws (4 for single oven, 6 for double oven) provided. Insert the screws through hole
9GAS CONVERSIONSGas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. LP Gas Conversion1. Tu
Comments to this Manuals