ELECTRIC DRYER27" WiDEINSTALLATI N INSTRMODELS - U.S.A. ONLYCTIONSPara obtener acceso al manual de uso y cuidado en espa_ol, o para obtener infor
4owire Direct Wire ConnectionIMPORTANT: A 4-wire connection is required for mobile homesand where local codes do not permit 3-wire connections.1, Prep
Optionam 3owire ConnectionIMPORTANT: You must verify with a qualified electrician thatthis grounding method is acceptable before connecting.Remove cen
Connect a separate copper ground wire (G) from the externalground conductor screw (A) to an adequate ground. Finally, reinserttab of terminal block co
Clamps:[] Use clamps to seal all joints.[] Exhaust vent must not be connected or secured with screwsor other fastening devices that extend into interi
Venting KitsFor more information, call 1-800-901-2042, or visit us atwww.appiianceaccessories.com, in Canada, call1-800-807-6777 or visit us at www.wh
"2. Connect vent to exhaust hoodLEVEL DRYERVent must fit over the exhaust hood. Secure vent to exhausthood with 4" (102 mm) clamp. Run vent
COMPLETE iNSTALLATiONCHECKLIST[_ Check that all parts are now installed. If there is an extrapart, go back through steps to see what was skipped.[_ Ch
4, Remove screws from hingesRemove screws attaching hinges to door.5, Remove screws from door\Remove screws at top, bottom, and side of door (6 screws
NOTE: 2 people may be needed to reinstall door.Insert screws into the bottom holes on left side of dryer cabinet.Tighten screws halfway. Position door
5, Rip door overFlip door over so handle side is down.\Remove screws at top, bottom, and side of door (4 screws).Keep door screws separate from hinge
DRYER SAFETYYour safety and the safety of others are very important.We have provided many important safety messages in this manual and on your applian
10, Remove door strike and doorstrike labelDoor strike labeldryer cabinetRemove door strike and door strike label from dryer cabinet.Insert the door s
IMPORTANT SAFETY INSTRUCTIONSWARNING." To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precau
Parts supplied:Leveling legs (4)Parts package is located in dryer drum. Check that all partsare included.Parts needed:Check local codes. Check existin
[][]Metal exhaust system hardware, which is available forpurchase from your dealer.Special provisions must be made in mobile homes tointroduce outside
iNSTALL LEVELING LEGSExcessive Weight HazardUse two or more people to move and install dryer.Failure to do so can result in back or other injury."
Direct WireFire HazardUse 10 gauge copper wire.Use a UL listed strain relief.Disconnect power before making electrical connections.Connect neutral wir
4owire Power Supply Cord ConnectionIMPORTANT: A 4-wire connection is required for mobilehomes and where local codes do not permit the use of 3-wirecon
Direct Wire ConnectionDirect wire strain reliefRemove center terminal block screw (B).Unscrew the removable conduit connector (A) and anyscrews from a
Comments to this Manuals