Whirlpool KGI 2951/A Instruction for Use Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
20
Before calling After-sales Service:
1.
See if you can solve the problem yourself
with the help of the "Troubleshooting Guide".
2.
Switch the appliance on again to see if the
problem persists. If it does, switch off and
wait for about an hour before switching on.
3.
If the problem persists after this action,
contact After-sales Service.
Specify:
the nature of the fault,
the model,
the service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance),
your full address,
your telephone number and area code.
Note:
The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
Install the appliance away from heat sources.
Installation in a hot environment, direct
exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will
increase power consumption and should
therefore be avoided.
If this is not possible, the following minimum
distances must be respected:
30 cm from coal or paraffin stoves;
3 cm from electric or gas cookers.
Install the appliance in a dry, well-ventilated
place.
Clean the interior (see the relative heading in
this handbook).
Fit the accessories.
Electrical connection
Electrical connections must be made in
accordance with local regulations.
Voltage and power consumption are
indicated on the rating plate inside the
appliance.
The appliance must be earthed by law.
The manufacturer declines all liability for
injury to persons or animals and for
damage to property resulting from failure
to observe the above prescriptions.
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance
by unplugging it or by means of a two-pole switch
fitted upline of the socket.
AFTER-SALES SERVICE
INSTALLATION
33051-gb.fm5 Page 20 Tuesday, December 22, 1998 3:52 PM
Page view 8
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments