Whirlpool 50 Hz Specifications download pdf (Page 8)

F. Protect Whirlpool Unit

Position a protective covering or similar material in the

bottom of the the unit. Be careful not to scratch the

surface of the product.

7) Centralise Grating with Waste Body by lining

up ribs of each directly in line and tighten Fixing

Screw with a coin or suitable screwdiver.

- handtight plus 1/4 turn should

be sufficient.

8) Adjust Plug by twisting Control Knob to the

'up' position and then fix Plug height by use of

Adjusting Screw .

9) Secure Flexible Pipe by tightening Compression

Nut against Compression Seal .

10) Set drain pipe , put on nut drain pipe , and then

tighten gasket .

Check if the pop-up mechanism is operating correctly.

If it doesn't the Plug height still needs adjusting or

Control Cable might be twisted or jammed. Proceed

with bath installation only after you've ensured the

drain is operating correctly.

Do not overtighten

-----

10)

-8-

Whirlpool Set-In

If the subfloor is not level, some shimming of the bath

will be necessary.

Set the whirlpool into installation. Make sure the unit is

level, and is resting on all supporting feet. Insert the

drain tailpiece into the trap. Apply a bead of silicone

sealant under the rim of the whirlpool.

Do not hang the whirlpool by the rim.NOTICE:

Bath Rim

1/16" (2mm) Gap

Between Bath Rim

and Framing

INSTALL THE WHIRLPOOLINSTALL THE WHIRLPOOL

1063633-T01-A

1 2 3 4 5 6 7 8 9 10 11

No comments

Whirlpool 50 Hz Specifications Page 8