Whirlpool AWZ 410 Instruction for Use Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
GB 7
Pouring in the detergents and additives
The detergent drawer has three chambers (fig. “
A
”).
Prewash Chamber
Detergent for the prewash
Main Wash Chamber
Detergent for the main wash
Stain remover
Water softener
Softener Chamber
Fabric Softener
Liquid starch
Pour additives only up to the “MAX” mark”.
Using bleach
Wash your laundry with the desired programme (Cotton,
Synthetics), adding an appropriate amount of bleach to the
SOFTENER chamber (close the detergent dispenser carefully)
Immediately after the end of the programme, start the “Rinse and
Spin” programme to eliminate any residual bleach smell; if you
want, you can add softener.
Never put both chlorine bleach and softener into the softener
chamber at the same time.
Using starch
Select the “Rinse and Spin” programme and check that the spin
speed is set to not more than 800 rpm.
Start the programme, pull out the detergent dispenser so that you
can see approximately 3 cm of the softener chamber.
Pour the starch solution prepared into the softener chamber
while the water is running into the detergent dispenser.
Position the liquid detergent separator in the main
wash chamber.
When you use a liquid detergent (recommended for non pre-wash
programmes), position the separator in the main wash chamber
on the guides so that it touches the bottom of the chamber
then pour in the detergent until it reaches the full mark.
Remember to remove the separator when you use a powder
detergent.
()
A
Separator
B
D
Separator
Type 2 basin
()
()
C
Separator
Rails
}
Type 1 basin
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments