Whirlpool HMMR 90430 Use and Care Guide

Health & Safety, Use & Care and Installation guidewww.maytag.co.uk/warranty

10PRODUCT DESCRIPTIONAPPLIANCECONTROL PANEL1. Worktop2. Control panel3. Water tank4. Door5. Door handle6. Door lter (behind door) 7. Plinth8. Adjus

11ENDOORDRUM LIGHT (if available)AVAILABLE ACCESSORIES To open the door, pull the handle.If you interrupt a running programme by opening the door, th

12FIRST TIME USEHOW TO USE THE APPLIANCE1. WHEN SWITCHING ON THE DRYER FOR THE FIRST TIME, YOU WILL BE ASKED TOSet the desired languageTurn the knob

13ENDAILY USE WARNINGMake sure that no lighters or matches remain in the laundry. Make sure that the laundry is not soaked with ammable liquids.1. L

14mum 180 minutes (three hours).Make sure that the Drying time button lights up. Turn the knob to select the desired drying / airing time. Conrm it b

15ENThe dryer switches o automatically in about a quarter of an hour after programme end, to save energy. If not switched o right after programme en

16PROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsSYNTHETICS For drying laundry made of synthetic bres.max. load (kg): 3.5default

17ENPROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsSTEAM REFRESH For refreshing laundry with steam. Specically designed to refresh

18max = maximum capacity of the dryer Programme durations indicated in the table are default values. The programme duration mainly depends on the hum

19ENSTEAM OPTIONFRESH CAREGENTLEDRYING TIME OPTIONDRYNESS LEVELMinimizes creasing of garments made of cotton, synthetics and their blends by adding a

2ENGLISH ...3

20FUNCTIONSON/OFFKNOBSTART/PAUSEKEY LOCKFINISH INTo switch the dryer on: press the button until the Start/Pause button lights up. To switch the dryer

21ENThe colon on the display between hours and minutes blinks. The programme starts automatically, in time to be nished at the end of the delay perio

22INDICATORSENERGY MONITORFAILUREThe less levels of the energy monitor are lit, the more economic is your programme setting.For any failure indication

23ENENERGY SAVING TIPS• To reduce the drying time, make sure that the laundry is spun with the maximum possible spin speed of the wash programme. Thi

24CLEANING & MAINTENANCEEMPTYING THE WATER TANKEmpty the water tank after each programme, provided the drain hose is not connected to your sewage

25ENClean the door lter after each programme.Make sure that the laundry is unloaded. Open the door.1. Remove the door lter by pulling it upwards. 2.

264. Clean the lter foam and the lter by hand or under running water. Do not wash the lter foam in the washing machine.5. Carefully wring out the 

27EN8. Insert the bottom lter again. Make sure that it is completely integrated in the lter compartment.9. Clap the lter handle downwards.10. Close

28CLEANING THE OUTSIDE OF THE DRYERUse a soft damp cloth to clean the outer parts of the dryer.Do not use glass or general purpose cleaners, scouring

29ENREVERSING THE DOOR STOPIf needed, the door stop of the dryer door can be reversed. Use pliers and a cross-head screwdriver for the procedure. For

3ENENGLISHHEALTH & SAFETY, USE & CARE and INSTALLATION GUIDESIndexHealth and Safety guideSAFETY INSTRUCTIONS ...

305. Fix the door on the left side by turning in the 2 screws. Take care to screw them in vertically, to avoid pinching o the door seal.6. Insert the

31ENYour dryer is equipped with various automatic safety functions. These enable failures to be detected in good time and the safety system can react

32WATER DROPLETS ARE BENEATH THE DRYERBottom lter not inserted correctly• Check position of the bottom lter and make sure it is completely integrat

33ENFAILURE INDICATOR AND MESSAGESMake sure to • Empty the water tank after each programme• Clean the door lter after each programme• Clean the bo

34Below is a summary of possible failure causes and solutions. If the problem persists after having followed the instructions as indicated below, pres

35ENTRANSPORT AND HANDLING1. Unplug the dryer.2. Make sure that door and water tank are properly closed.3. If the drain hose is connected to your sewa

36AFTER-SALES SERVICEBEFORE CALLING THE AFTER-SALES SERVICEIF AFTER THE ABOVE CHECKS THE FAILURE STILL OCCURS, GET IN TOUCH WITH THE NEAREST AFTER-S

37EN2a. 2b.1.

383a.3b.max 2 cmmax 0.79 inch

39EN4.max 100 cm39 inch12

4ENERGY SAVING ...23CLEANING & MAINTENANCE ...

405.6a.6b... xxx V ~ xx Hz xx A IPX4 EV Dxxxx xxxx xxxx

41ENEN400010822937001n®/TM © 2015 Maytag. All rights reserved.

5ENSAFETY INSTRUCTIONSIMPORTANT TO BE READ AND OBSERVEDBefore using the dryer carefully read, Health and Safety and Use and Care guides.Keep these in

6cycle unless all items are quick-ly removed and spread out so that the heat is dissipated.The last phase of the drying cy-cle is done without heat (c

7ENfuse cover. 3. Ret both into plug.Important:The fuse cover must be retted when changing a fuse and if the fuse cover is lost the plug must not be

8SCRAPPING OF HOUSEHOLD APPLIANCESWhen scrapping the dryer, make it unusable by cutting o the power cable and removing the doors and shelves (if pre-

9ENDECLARATION OF CONFORMITYThis dryer has been designed, constructed and distributed in compliance with the safety requirements of European Directiv