WASHER INSTALLATION INSTRUCTIONSWASHER SAFETYW10038100Table of ContentsWASHER SAFETY... 1INSTALLATION REQUIRE
2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. The parts supplied are in the washer basket
3Recessed area or closet installationThe dimensions shown are for the recommended spacing allowed (A and B), except the closet door ventilation openin
4 To minimize possible shock hazard, the cord must be plugged into a mating, earthing-type outlet, earthed in accordance with local codes and ordinan
52. Firmly grasp the power cord and pull to completely remove the power cord, cord restraint, and pin from the rear panel. 3. Confirm that the power c
6 Then slide the second hose clamp onto coupling. Insert end of adapter into coupling. Use a screwdriver to install second hose clamp over coupling.
7NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result. 5. Attach the cold water hose to the top inlet valve.
2. Tilt the washer forward until the rear of the washer is at least 10.2 cm (4") off the floor. You may hear the self-adjusting rear feet click i
Comments to this Manuals