Whirlpool WHER25 Specifications download pdf (Page 10)

Step C - Install RO Filter Assembly

INSTALL STORAGE TANK

Apply thread sealing tape (2 wraps clockwise) to

the threads on the nipple at the top of the tank. See

Fig 13.

2. Locate the tubing connector. See Fig. 13. Slowly

tighten the tubing connector onto the tank nipple 7-8

full turns, so as not to cross thread or overtighten.

3. Do not connect the tube at this time. This will occur

later in the assembly.

4. Place the storage tank next to the Reverse Osmosis

Assembly. The tank can be placed upright or on its

side.

INSTALL REVERSE OSMOSIS FILTER

ASSEMBL

The Reverse Osmosis Filter Assembly is mounted on

hanger washers.

See Fig 12. The hanger washers allow you to lift the

filter assembly from the washers without any hardware

removal. When planning your installation, you need to

leave room for changing filters.

Complete the following steps to install your Reverse

Osmosis Filter Assembly:

1. Remove the cover.

2. Locate mounting slots on back inside of the assem-

bly. See Fig 12.

3. Hold the assembly up to the wall surface and mark

locations for the hanger washers. See Fig 12. Mount

the unit high enough to allow room to change filters

without taking the unit off of the wall.

4. Fasten the hanger washers to the wall using the

screws provided.

5. Hang assembly on washers.

6. Replace cover.

Screw (2)

15-1/2'' minimum up

from floor. This allows

space to remove and

change filters

9''

Hanger

asher (2)

Step D - Install Storage Tank

FIG. 12

FIG. 13

Tank

Nipple

Storage

Tank

Tubing Nut

Tubing Insert

Tubing Connector

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comments to this Manuals

No comments

Whirlpool WHER25 Specifications Page 10

Comments to this Manuals

Related products and manuals for Water dispensers Whirlpool WHER25