Whirlpool GBS307 User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a click as the door is set into place.
3. Move the hinge levers back to the locked position. Ensure
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Is the appliance wired properly?
See Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly?
See Electronic Oven Control section.
Has a delay start been set?
See Timed Cooking section.
On some models, is the Control Lock set?
See Control Lock section.
On some models, is the Sabbath Mode set?
See Sabbath Mode section.
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning the other oven cannot be set
or turned on.
On double oven models, has the correct oven been
selected?
Choose UPPER OVEN or LOWER OVEN first.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See Oven Temperature Control section.
Display shows messages
Is the display showing PF, PF id=27 or PF id=30?
There has been a power failure. Clear the display. See
Display(s) section. On some models, reset the clock, if
needed. See Clock section.
Is the display showing a letter followed by a number?
Clear the display. See Display(s) section. If it reappears, call
for service. See Assistance or Service section.
Self-Cleaning cycle will not operate
Is the oven door open?
Close the oven door all the way.
Has the function been entered?
See Self-Cleaning Cycle section.
On some models, has a delay start Self-Clean cycle been
set?
See Self-Cleaning Cycle section.
Has a delay start been set?
See Timed Cooking section.
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning, the other oven cannot be set
to self-clean.
Page view 13
1 ... 13 14 15 16

Comments to this Manuals

No comments