Whirlpool ADG 4620 A+ IX Instruction for Use

Browse online or download Instruction for Use for Dishwashers Whirlpool ADG 4620 A+ IX. Whirlpool ADG 4620 A+ IX Instruction for Use [fr] User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
EN -1-
Chart
(see at right for
options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks. To resume the cycle close
the door and push Start button again.
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter “What to do if...”.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options)
and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the
appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information
on the EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
* Power consumption in: Left-on mode: 0.70 W / Off mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Delay Crockery to be washed later. 4.0 0.01 14-16 NO
2
Rapid 45°C
Delay
Lightly soiled crockery, with no dried-on
food.
X 11.0 0.85 30-50 NO
3
Eco
2)
50°C
Delay
Normally soiled crockery.
Standard program the most efficient in
terms of its combined energy and water
consumption.
X 12.0 1.02 170 Full
4
Hygiene
Delay
Normally and heavily soiled crockery,
with additional hygiene wash. Program
interruption (e.g. due to door opening)
can compromise elimination of germs.
X 14.0 1.40 110-120 Full
5
Intensive 65°C
Delay
Recommended program for heavily soiled
crockery, especially suitable for pans and
saucepans.
X 15.0 1.60 165-175 Full
5019 300 01599
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and detergent in 1 dose).
If you are using powder detergent or gel detergent,
the Tablet indicator on the control panel has to be off.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 01599

EN -1-Chart(see at right for options description)START/RESUME BUTTONPush this button to start the selected program: the indicator lights up and goes o

Page 2 - Daily check

EN -2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load the racks

EN -4-How to load the racksCLICK!D - OPENLOWER RACK - depending on the model4A - Adjustable flaps (2 or 4): in horizontal position for cups / long ute

Page 5 - Maintenance and care

EN -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A

Comments to this Manuals

No comments