EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the
cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push Start button and close
the door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other
tests, contact the following addres
s: “[email protected]”.* Power consumption in: Left-on mode: 1.50 W / Off-mode: 0.50 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor 40°-70°C
Delay,
Multizone,
Antibacterial rinse
Use for normal soiled dishes with dried-on food.
Senses the level of soiling on the dishes and
adjusts the program accordingly. When the
sensor is detecting the soil level an animation
appears in the display and the cycle duration is
updated.
X 7.5-13 0.95-1.45 85-175 Full
P2
Pre-Wash cold
Delay, Multizone Crockery to be washed later. – 4.0 0.01 14-16 NO
P3
Fragile 40°C
Delay,
Multizone
Light soiling, for example glasses and cups. X 10.5 0.85 105-114 Light
P4
Rapid 45°C
Delay,
Multizone
Lightly soiled crockery, with no dried-on food. X 11.0 0.85 30-50 NO
P5
Eco
2)
50°C
Delay,
Multizone,
Antibacterial
rinse
Normally soiled crockery.
Standard program the most efficient in terms of
its combined energy and water consumption.
X 10.0 0.922 240 Full
P6
Daily 60°C
Delay,
Multizone,
Antibacterial rinse
Normally soiled crockery. X 11.0 1.30 80-95 Full
P7
Intensive 65°C
Delay,
Multizone,
Antibacterial rinse
Recommended program for heavily soiled
crockery, especially suitable for pans and
saucepans.
X 15.0 1.60 165-175 Full
P8
Steam
Delay,
Multizone,
Antibacterial rinse
Program inclouding steam action dedicated for
heavilly soiled crockery, pots and pans. Soaking or
hand pretreatment is no longer needed.
X 14.5 1.75 180-190 Full
400010789335
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE
CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER
30 SECONDS IF NO CYCLE HAS STARTED.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
ANTIBACTERIAL RINSE
This function activates an antibacterial
rinse at the end of the wash cycle,
guaranteeing a further reduction of
bacteria. Press the button to activate
or deactivate the function.
This function can be used with the
programs indicated in the table of
programs. The dishwasher door must
be kept shut for the entire duration of
the program in order to guarantee
reduction of bacteria. If the door is
opened the indicator lamp starts
flashing.
- indicator lits
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds
(until the indicator lights
up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours.
With each press of the
button, the delayed start
indicator increases by
one hour and after
24 restarts from 0.
Then press the START
button.
The dishwasher will
start after the set time.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle), the
rinse aid dispenser needs to be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
Reference guide
Whirlpool is a registered trademark of Whirlpool USA
(8 pages)
(8 pages)
(8 pages)
(8 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals