search

Whirlpool ADG 6442 IX Instruction for Use Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 5
GB
-6-
What to do if...
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.
Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation.
How the faults are shown on the display: Function number “F”x - blinking Error number “E”y - blinking 0.5 sec. pause
The appliance... Possible causes... Solutions...
...is not working/will not start
- The appliance must be switched on. - Check the household circuit fuse if there is no power supply.
- The dishwasher door doesn’t close. - Check if the dishwasher’s door is closed.
- “Delayed start” option is ON.
- Check whether the “Delayed start” option (if available) has been selected. If it has, the appliance will only start once the set
time has elapsed. If necessary, set the delayed start to “0” (RESET the appliance).
...shows “F6 E2”
- Water tap closed. - The water tap must be open.
- Kinked water inlet hose or clogged inlet filters. - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be clogged.
...shows “F6E7” or “F6E1”
- Water pressure too low. - The water tap must be fully open during water inlet (minimum capacity: 0.5 litres per minute).
- Kinked water inlet hose or clogged inlet filters. - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty.
...shows “F6 E3”/wash program ended too
early (dishes are dirty and wet)
- Dirty or clogged filters. - The filters must not be dirty or clogged.
- Too little water in the dishwasher’s water system. - Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack.
- Drain hose incorrectly fitted.
- The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the
appliance) - see Assembly instructions.
- High level of foam inside. - Repeat without detergent or wait until foam disappears.
...shows “F8 E1”
-Dirty filters. - Clean the filters.
- Kinked drain hose. - The drain hose must not be kinked.
- Syphon hose connection closed. - The closure disk of the syphon hose connection must be removed.
After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated.
RESET: Press the CANCEL/Off button.
Close the door.
Water drains automatically for up to 1 minute.
The appliance is now ready to be restarted.
Crockery and cutlery... Possible causes... Solutions...
...are not perfectly clean/have food residues
- Too little space between dishes (incorrect arrangement of the
concave items in the rack).
- Arrange crockery so that items do not touch each other. Concave items (e.g. bowls, cups) must be arranged facing
downwards in the rack.
- Too little detergent; detergent too old or incorrectly stored.
- If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a
dry place and do not store it for excessively long periods of time.
- Temperature not high enough for heavily soiled crockery. - For heavily soiled crockery, select a wash program with a higher temperature (see table of programs - page 1).
- Loading of the dishwasher using lower and upper rack at the
same time with “Half load/Multizone” option.
- If you select the “Half load/Multizone” option (if available), remember to load
only
the upper rack or
only
the lower rack to
increase washing power and thus obtain optimum wash results.
- Frequent use of Eco 50°C.
- In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 70°C program (if
available).
- Clogged spray arms, dirty filters or not fitted correctly. - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, “Maintenance and care“).
- Spray arms stuck impeded by crockery or cutlery. - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery.
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments
Related products and manuals for Dishwashers Whirlpool ADG 6442 IX
Dishwashers Whirlpool WSFP 4O23 PF X User's Guide   (12 pages)
Dishwashers Whirlpool GSUK 61202 TR A+ IN Instruction for Use   (12 pages)
Dishwashers Whirlpool GSX 7976 Instruction for Use   (12 pages)
Dishwashers Whirlpool WP 75/6 Instruction for Use   (8 pages)
Dishwashers Whirlpool GCX 4861 Instruction for Use   (29 pages)
Dishwashers Whirlpool WP 79/3 LD Instruction for Use   (8 pages)
Dishwashers Whirlpool ADG 201 Instruction for Use   (10 pages)
Dishwashers Whirlpool ADG 8720 FD Instruction for Use   (8 pages)
Dishwashers Whirlpool GSU PRIMELINE 9717 IN Instruction for Use   (8 pages)
Dishwashers Whirlpool WP 88/1 Instruction for Use   (1 pages)
Dishwashers Whirlpool ADG 9041 FD Instruction for Use   (12 pages)
Dishwashers Whirlpool GSI 61202 TR A+ IN Instruction for Use   (12 pages)
Dishwashers Whirlpool WP 76/1 Instruction for Use   (8 pages)
Dishwashers Whirlpool IGV 645.1 Instruction for Use   (10 pages)
Dishwashers Whirlpool ADG 6600 Instruction for Use   (8 pages)
Dishwashers Whirlpool RBC 3B+26 X User's Guide   (8 pages)
Dishwashers Whirlpool ADG 9820 IX A+ Instruction for Use   (8 pages)
Dishwashers Whirlpool GSXP 6141 A+ Di Instruction for Use   (8 pages)
Dishwashers Whirlpool RIE 2C19 User's Guide   (8 pages)
Dishwashers Whirlpool GSXP 81312 TR A+ Instruction for Use   (12 pages)
  • Avallon Jj-astro Qvidium Flaem Krona
  • Jabra Battery chargers Honeywell Space heaters Ninja Blenders Fortinet Network transceiver modules Aiphone Telephones
  • Casio AP-6BP Xerox 6180/DN Admiral Craft CVYT-120 Vivitek LCD-TV
  • Linksys LGS528P User's Guide Heidolph Hei-VAP Precision User Manual Nikon Coolpix P80 User Manual LG B2100 User Manual Sony SRS-BT100 User Manual