Whirlpool ADG 8930 IX Instruction for Use download pdf

-1-

Chart

START

DELAY

option

MULTI

ZONE

option

POWER

CLEAN

option

ON/OFF

BUTTON

PROGRAMME

SELECTION

BUTTON

(see “Table of

programmes”

below).

START BUTTON

The indicator lights up during operation, flashes when a fault occurs,

and goes off at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will be

cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be

cancelled by RESETTING. Detailed instructions are given in chapter “What to do if...”.

(see at right for options description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions

Litres kWh

Minutes

Aqua Steam 40-70°C

Delay

Multizone

Power Clean

Normally or heavily soiled crockery,

including pots and pans. Thanks to

steam action, soaking or hand

pretreatment is no longer needed. In

addition hygiene is ensured due to

the high temperature steam.

X 7-15 0.99-1.75 65-205

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14

Glasses 40°C

Delay

Multizone

Light soiling, for example glasses

and cups.

X 10.0 0.85 100

Quickwash 45°C

Delay

Multizone

Lightly soiled crockery, with no

dried-on food.

Not recommended tablets

use.

11.0 0.80 30

Eco

50°C

Delay

Multizone

Power Clean

Normally soiled crockery.

Energy-saving programme.

X 11.0 1.05 170

Antibacterial

Delay

Multizone

Power Clean

Normally or heavily soiled

crockery, with additional

antibacterial wash. Programme

interruption (e.g. due to door

opening) can compromise

elimination of germs.

X 13.0 1.50 115

Overnight 55°C

Delay

Multizone

Normally soiled crockery, gentle

and quiet thanks to the lower spray

pressure (39dbA).

X 13.0 1.20 290

DELAYED START

BUTTON

Press the button

(repeatedly) to delay the

start of the programme.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases by

one hour and after 24

restarts from 00. Then

press the START button.

The dishwasher will start

after the set time.

5019 396 01822ADG 8930

MULTIZONE

Allows you to choose the

washing zones. Press this

button to select the wash

zones (the display shows

the corresponding symbol):

both racks

(off - no symbols)

only upper rack

only lower rack

POWER CLEAN

Thanks to the additional

power jets this option

provides a more intensive

and powerful wash in the

lower rack, in the specific

area.This option is

recommended for washing

pots and casseroles (see

page 4). Press this button

to activate Power Clean

(the display shows the

corresponding symbol).

RINSE AID INDICATOR

When lit, the rinse aid dispenser

needs to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it indicates

the time remaining until programme start (hh).

If “F..” appears on the display, see chapter “What to do if...”.

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE ASSEMBLY

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

PROGRAMME SEQUENCE

INDICATOR

Prewash Washing Drying

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01822ADG 8930

GB -1-ChartSTARTDELAYoptionMULTIZONEoptionPOWERCLEANoptionON/OFFBUTTONPROGRAMMESELECTIONBUTTON(see “Table of programmes” below).START BUTTONThe indica

Page 2 - First time use

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3

GB -3-Daily check ELSSELELSELS123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt

Page 4

GB -4-A - Two trays forcutlery(In some models only)B - Adjustable glass holderHow to adjust upper rack height (if available) - It could be useful to l

Page 5 - • Press the START button

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faul

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap.Contact the Af