Whirlpool ADG 8990 Instruction for Use download pdf

-1-

Chart

(see at right for options description)

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the required

programme number appears on the display (see

“Table of programmes” below).

START BUTTON

The indicator lights up during operation,

flashes when a fault occurs and goes off at

the end of the programme.

BUTTON

OFF

BUTTON

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time (h:mm), whereas with

“Delayed start” selected it indicates the time remaining until programme

start (hh).

If “F..” appears on the display, see chapter “What to do if...”.

RESET BUTTON

For programme change or indication of faults.

Press this button to cancel a started programme and selected extra

options. Press this button to cancel the main fault indicators “F..”

also refer to the chapter “What to do if...”. The programme can then

be selected and started.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional

options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of

the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on

the EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions

Litres Kwh

Minutes

Aqua Steam 40-70°C

Delay

Multizone

Antibacterial

rinse

Normally or heavily soiled crockery,

including pots and pans. Thanks to steam

action, soaking or hand pretreatment is no

longer needed. In addition hygiene is

ensured due to the high temperature steam.

X 7-15 0.99-1.75 65-205

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14

Glasses 40°C

Delay

Multizone

Light soiling, for example glasses and cups. X 10.0 0.85 100

Quickwash 45°C

Delay

Multizone

Lightly soiled crockery, with no dried-on

food.

Not recommended tablets use.

11.0 0.80 30

Bio

50°C

Delay

Multizone

Antibacterial

rinse

Normally soiled crockery.

Energy-saving programme.

X 11.0 0.98 170

Overnight 55°C

Delay

Multizone

Normally soiled crockery, gentle and quiet

thanks to the lower spray pressure

(39dbA).

X 13.0 1.20 290

5019 396 01790ADG 8990

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE ASSEMBLY

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

HALF LOAD/

MULTIZONE

Allows you to choose

the washing zones.

Press this button

(repeatedly) to select

the wash zones:

both racks

only upper

rack

only lower

rack

ANTIBACTERIAL

RINSE

This function activates

an antibacterial rinse at

the end of the wash

cycle, guaranteeing a

further reduction of

bacteria.

Press the button to

activate or deactivate

the function. This

function can be used

with those

programmes marked

with the relative

description in table.

The dishwasher door

must be kept shut for

the entire duration of

the programme in

order to guarantee

reduction of bacteria. If

the door is opened the

indicator lamp starts

flashing.

RINSE AID

INDICATOR

When lit, the rinse aid

dispenser needs to be

refilled.

SALT INDICATOR

When lit, the salt

reservoir needs to be

refilled.

SET THE

DETERGENT

Press this button

(repeatedly) to set the

type of detergent used.

Powder, gel

(standard)

Detergent

with rinse aid

Detergent

with salt +

rinse aid

RUNNING PROGRAMME

INDICATOR

A LED light projected on the

floor indicates that the

dishwasher is working.

DELAYED START

BUTTON

Press the button

(repeatedly) to delay

the start of the

programme.

Adjustable from 1 to 24

hours. With each press

of the button, the

delayed start indicator

increases by one hour

and after 24 resets

from 00. Then press

the START button. The

dishwasher will start

after the set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01790ADG 8990

GB -1-Chart(see at right for options description)PROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the required programme number appears o

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check23Rinse aid indicator (depending on model)The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.dark: OK

Page 4 - How to load the racks

GB -4-How to load the racksHow to load LOWER RACK4(In some models only)A - Dish holder: In horizontal position for cups/long utensils. In raised posit

Page 5 - Maintenance and care

GB -5-Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating678Exercise caution when opening the door:

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faul

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap.Contact the Af

Comments to this Manuals

No comments

Whirlpool ADG 8990 Instruction for Use

Browse online or download Instruction for Use for Dishwashers Whirlpool ADG 8990. Whirlpool ADG 8990 Instruction for Use [de] User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool ADG 8990