Whirlpool ADG 9030 Instruction for Use download pdf

-1-

Chart

(see at right for options description)

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the

required programme number appears on

the display (see “Table of programmes”

below).

START BUTTON

The indicator lights up during operation,

flashes when a fault occurs and goes off at

the end of the programme.

BUTTON

OFF

BUTTON

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time (h:mm), whereas with

“Delayed start” selected it indicates the time remaining until programme

start (hh).

If “F..” appears on the display, see chapter “What to do if...”.

RESET BUTTON

For programme change or indication of faults.

Press this button to cancel a started programme and selected extra

options. Press this button to cancel the main fault indicators “F..”

also refer to the chapter “What to do if...”. The programme can then

be selected and started.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Detergent

Consumption

Programmes

Available

options

Loading instructions Litres Kwh

Minutes

Aqua Steam 40-70°C

Delay

Multizone

Power Clean

Normally or heavily soiled crockery,

including pots and pans. Thanks to

steam action, soaking or hand pre-

treatment is no longer needed. In

addition hygiene is ensured due to

the high temperature steam.

X 7-17 0.99-1.75 65-220

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14

Glasses 40°C

Delay

Multizone

Light soiling, for example glasses and

cups.

X 10.0 0.85 100

Quickwash 40°C

Delay

Multizone

Lightly soiled crockery, with no

dried-on food.

* Not recommended tablets use.

10.0 0.65 30

Eco

50°C

Delay

Multizone

Power Clean

Normally soiled crockery.

Energy-saving programme.

X 11.0 1.05 165

Antibacterial

Delay

Multizone

Power Clean

Normally or heavily soiled crockery,

with additional antibacterial wash.

Programme interruption (e.g. due to

door opening) can compromise

elimination of germs.

X 13.0 1.50 115

Overnight 55°C

Delay

Multizone

Normally soiled crockery, gentle and

quiet thanks to the lower spray

pressure (39dbA).

X 13.0 1.20 290

5019 396 01746ADG 9030

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

HALF LOAD/

MULTIZONE

Allows you to choose

the washing zones.

Press this button

(repeatedly) to select

the wash zones:

both racks

only upper

rack

only lower

rack

POWER CLEAN

Thanks to the

additional power jets

this option provides a

more intensive and

powerful wash in the

lower rack, in the

specific area. This

option is

recommended for

washing pots and

casseroles

(see

page 4)

. Press this

button to activate

Power Clean (the

indicator lights up).

RINSE AID

INDICATOR

When lit, the rinse aid

dispenser needs to be

refilled.

SALT INDICATOR

When lit, the salt

reservoir needs to be

refilled.

SET THE

DETERGENT

Press this button

(repeatedly) to set the

type of detergent used.

Powder, gel

(standard)

Detergent

with rinse aid

Detergent

with salt +

rinse aid

RUNNING PROGRAMME

INDICATOR

A LED light projected on the

floor indicates that the

dishwasher is working.

DELAYED START

BUTTON

Press the button

(repeatedly) to delay

the start of the

programme.

Adjustable from 1 to 24

hours. With each press

of the button, the

delayed start indicator

increases by one hour

and after 24 resets

from 00. Then press

the START button. The

dishwasher will start

after the set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01746ADG 9030

GB -1-Chart(see at right for options description)PROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the required programme number appears o

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check23Rinse aid indicator (depending on model)The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.dark: OK

Page 4

GB -4-A - Two trays forcutlery(In some models only)B - Adjustable glass holderHow to adjust upper rack height (if available) - it could be useful to l

Page 5 - Maintenance and care

GB -5-109678Overview of programmesThe max. possible number of programmes is illustrated in this overview. The corresponding programmes for your applia

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off th