EN -1-
Chart
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter “What to do if...”.
START/RESUME BUTTON
Push this button to start the selected program:
the indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused:
the Start indicator blinks. To resume the cycle
close the door and push Start button again.
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “contact@whirlpool.com”.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Sensor 50°-65°C
Delay
Recommended program for
routine washes, with dried-on
food.
X 7-15 1.00-1.70 70-172 Full
2
Rapid 45°C
Delay
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.85 30-50 NO
3
Eco
2)
50°C
Delay
Normally soiled crockery.
Standard program the most
efficient in terms of its combined
energy and water consumption.
X 12.0 1.03 155 Full
4
Hygiene
Delay
Normally and heavily soiled
crockery, with additional
antibacterial wash. Program
interruption (e.g. due to door
opening) can compromise
elimination of germs.
X 14.0 1.40 110-120 Full
5
Intensive 65°C
Delay
Recommended program for heavily
soiled crockery, especially suitable
for pans and saucepans.
X 15.0 1.60 165-175 Full
5019 300 01347
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and detergent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
Comments to this Manuals