Whirlpool ADP606F/IX ECO Instruction for Use

Browse online or download Instruction for Use for Dishwashers Whirlpool ADP606F/IX ECO. Whirlpool ADP606F/IX ECO Instruction for Use [en] User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions.
Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.
A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product conditions.
* Power consumption in: Left-on mode: 0.70 W; Off-mode: 0.40W
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Aqua Steam 40°-70°C
Delay
Multizone
Anitbacterial Rinse
Normally or heavily soiled
crockery, including pots and
pans. Thanks to steam action,
soaking or hand pretreatment
is no longer needed. In addition
hygiene is ensured due to the
high temperature steam.
X 7-14 0.99-1.80 70-160 Full
2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. 4.0 0.01 14-16 NO
3
Glasses 40°C
Delay
Multizone
Light soiling, for example
glasses and cups.
X 10.5 0.85 105-114 Light
4
Quickwash 45°C
Delay
Multizone
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.85 30-50 NO
5
Eco
2)
50°C
Delay
Multizone
Anitbacterial Rinse
Normally soiled crockery.
Standard program the most
efficient in terms of its
combined energy and water
consumption.
X 6.0 1.03 170 Full
6
Overnight
Delay
Multizone
Normally soiled crockery, gentle
and quiet thanks to the lower
spray pressure (39 dbA).
X 10.0 1.20 290-299 Light
5019 300 01630
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE WAS STARTED.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lights
ANTIBACTERIAL RINSE
This function activates an
antibacterial rinse at the end of the
wash cycle, guaranteeing a further
reduction of bacteria. Press the utton
to activate or deactivate the function.
This function can be used with the
programs indicated in the table of
programs. The dishwasher door
must be kept shut for the entire
duration of the program in order to
guarantee reduction of bacteria.
If the door is opened the indicator
lamp starts flashing.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds
(until the indicator lights
up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after 24
restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 01630

EN -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “Programs” button (repeatedly) until the indicator of the required progr

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksCLICK!HGD - OPENLOWER RACK - depending on the model4B - Cutlery basket: can be placed in the upper rack when the “Half load

Page 5 - Maintenance and care

EN -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A

Comments to this Manuals

No comments