Whirlpool GSIK 6518/1 IN Instruction for Use download pdf

5019 496 01114

GSIK 6518

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on

the EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

Programme selector

START button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected

programme and options are cancelled. Main failure

displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions

are given in chapter 5 “What to do, if...”.

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Fault indication and wash time display

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

If “F..” appears on the display, see chapter 5 “What to do, if...”.

“Delayed start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each

press of the button, the delayed start indicator increases by

one hour and after 24 restarts from 00. Then press the

START button. The dishwasher will start after the set time.

Detergent setting upon initial use and when using a different type of

detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined

action detergents (in this way, the rinse aid and/or salt indicator is

deactivated).

Display shows OFF = Powder detergent (factory setting).

(rinse aid level and salt level indicator activated).

4. Switch the appliance off and then switch it on again. The selected

detergent type will be indicated on the display for approx. 3 seconds.

On / Off button

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Selectable

extra

functions

Loading instructions

large small Litres kWh Minutes

Quickwash 45°C

Slightly soiled crockery, without dry

residuals.

X — 11.0 0.80 30 ±

Bio Normal

50°C

Normally soiled crockery.

Energy-saving programme.

X X 12.0 1.05 165 ±

Intensive 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans.

X X 14.0 1.55 155 ±

Hygienic +

Normally or heavily soiled crockery,

with additional antibacterial wash. An

interruption of the programme (e.g.

due to door opening) can

compromise elimination of germs.

X X 13.0 1.50 115 ±

Half load 50°C

Ideal for washing a half load of

lightly or normally soiled crockery.

X X 10.0 1.04 145 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

5019 496 011141GBGSIK 6518Before using the dishwasher, read the installation and maintenance instructions carefully!1) Programme data obtained in conf

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given on the following pages; also see section “5. What to do, in case of...”1. Switch on the appli

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button “Select programme” or the programme selector to display the selected programme. The ap

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on the modelLong-handled utensils (kitchen knives) must be arranged with the s

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l