Whirlpool GSX 7961 Instruction for Use download pdf

5019 496 01145

Read the installation and maintenance instructions carefully before using the dishwasher!

GSX 7961

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, different settings, water supply temperatures, water hardness and power supply voltage.

2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:

for more detailed information

on the conditions of the EN comparison test and other tests, contact the following address: “[email protected]”.

1. OVERVIEW

Programme selection button

Press the button (repeatedly) until the indicator lamp of the

desired programme lights up (see table 1.1).

At the end of the wash cycle, the last programme selected is

memorised.

Half load/Multizone button

Load the upper or lower rack only.

Factory setting = Wash upper and lower rack (both indicator

lamps light up)

Press once = Wash lower rack (the indicator lamp lights up)

Press twice = Wash upper rack (the indicator lamp lights up)

At the end of the programme, the most recently selected

setting remains memorised.

If the upper rack is not being washed, the “Wash lower rack”

indicator lamp should be lit.

Rotating Power Clean

This function is activated by pressing (short) the button (the

indicator lamp lights up).

High pressure with an additional jet for better washing results

and greater lower rack load flexibility.

At the end of the programme, the most recently selected

setting remains memorised.

Detergent setting upon initial use and when using a different

type of detergent

Indicator lamp off = Powder/gel detergent (factory setting).

If using combined detergents, press and hold down the button

for 3 seconds; the indicator lamp lights up = rinse aid and salt

indicators are deactivated.

From water hardness level 5, the salt indicator remains active.

At the end of the programme, the most recently selected

setting remains memorised.

Fault indication and wash time display

In normal operation it indicates the remaining time (h:min),

whereas with “Delayed start” selected it indicates the time

remaining until programme start (e. g. h 01). If using a sensor

programme, a dotted line indicates that the calibration process

is underway (lasting up to 20 minutes).

In the presence of a fault indication “F.. / E..” - , refer to Section

5 “What to do if...”.

Delayed Start button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each press of

the button, the delayed start indicator increases by 1 hour, and

after “h 24” restarts from “h 00”. Then press the START

button. The wash programme will start after the set time.

Start/Resume button

The indicator lamp lights up during operation, flashes when the

programme is interrupted and goes off at the end of the

programme.

Cancel/Off button

Press the button to switch the dishwasher off or to interrupt the

selected programme.

If the Cancel/Off indicator lamp flashes repeatedly, this indicates

a fault: see 5 Section “What to do if...”.

Salt level indicator and rinse aid level indicator

These light up at the end of the programme if salt or rinse aid

needs topping up. Only add just before starting a wash cycle.

Table 1.1.

Overview of programmes

Detergent

dispenser

Consumption

Programmes

Additional

options

Description of

programme

large small Litres kWh Minutes

Sensor 40-70°C

Normally or heavily soiled

crockery, including pots and

pans.

X X 7-14 0.99-1.80 70-185 ±

Pre-Rinse cold

Crockery to be washed later. — — 4.0 0.03 14 ±

Quickwash 45°C

Lightly soiled crockery, with no

dried-on food.

X — 11.0 0.80 30 ±

Bio Normal

50°C

Normally soiled crockery.

Energy-saving programme.

X X 11.0 0.98 170 ±

Daily Quickwash 60°C

Normally soiled crockery. X — 10.0 1.30 80 ±

Intensive 70°C

Recommended programme for

heavily soiled crockery,

especially suitable for pots and

pans.

X X 14.0 1.55 155 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

5019 496 01145Read the installation and maintenance instructions carefully before using the dishwasher!1GBGSX 79611) Programme data obtained in confor

Page 2 - 2. QUICK REFERENCE GUIDE

2Change the programme in progress:- Press the Cancel/Off button.- Close the door.- (Water drains for up to 60 seconds).- Open the door.- Select a

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEHOW TO FILL THE DETERGENT DISPENSEROnly fill the detergent dispenser prior to starting a wash programme. Only use detergen

Page 4

43. HOW TO USE THE APPLIANCEHOW TO CHECK/FILL/ADJUST SALTOnly use regeneration salt specifically intended for dishwashers.a. How to check the salt lev

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSCUTLERY RACK:May be used in two different positions.In position 2 the upper rack must be lowered (see

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackagingThe packaging materials are 100% recyclable and marked with the recycling symbol .2. Removing

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-Sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l