Whirlpool GSXK 7524/3 Instruction for Use download pdf

5019 496 01118

GSXK 7524

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on

the EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

ON button

OFF button

Fault indication and wash time display

With “Delayed start” selected it indicates the time

remaining until programme start (hh). Near the end of

the programme, the time remaining in minutes is

displayed during the drying cycle.

In the presence of a fault indication “F..” –, consult

section 5 “What to do, in case of …”.

“Delayed start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each

press of the button, the delayed start indicator increases

by one hour and after 24 restarts from 00. Then press

the START button. The dishwasher will start after the set

time.

Programme selection button

Press the button (repeatedly) until the required

programme indicator lights up.

START button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds to cancel a started

programme and selected extra functions. The main fault

indications (repeated flashing of the START indicator) can

be cancelled by RESETTING. Also refer to section 5

“What to do, if...”.

The acoustic signal continues to sound as long as the

error persists.

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Selectable extra

functions

Loading instructions large small Litres kWh Minutes

Auto Sensor 50-65°C

Recommended programme for daily

use, with dry food residuals (e.g. EN

50242).

X X 11-16 1.10-1.50 100-130 ±

Quickwash 40°C

Lightly soiled crockery, without dry

residuals.

X — 11.0 0.80 30 ±

Bio Normal

50°C

Normally soiled crockery.

Energy-saving programme.

X X 12.0 1.05 165 ±

Hygienic +

Normally or heavily soiled crockery,

with additional antibacterial action. An

interruption of the programme (e.g.

due to door opening) can compromise

elimination of germs.

X X 13.0 1.50 115 ±

Intensive 70°C

Recommended programme for very

soiled crockery, particularly suitable

for pots and pans.

X X 14.0 1.55 155 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

5019 496 011181GBGSXK 7524Before using the dishwasher, read the installation and maintenance instructions carefully!1) Programme data obtained in conf

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on the modelLong-handled utensils (kitchen knives) must be arranged with the s

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l