Whirlpool UDT555SAHP Use and Care Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
To add rinse aid, open the dispenser lid
by gently pushing in the center of the
lid with your thumb while lifting
up on the edge.
Pour rinse aid into the opening until the
indicator level shows that it is full. Do
not ll the reservoir above the full level
indicator. Excess rinse aid can cause
suds and water to overow during the
wash cycle.
Close dispenser by pushing down
gently on the lid until it clicks into place.
5. Select a cycle
NOTE: Heavier cycles and options lengthen cycle times. Choose a
cycle appropriate for the food soils and dishes that you load. See the
cycle descriptions in the Cycle Guide.
6. Select options
You can customize your cycles by selecting
the options desired (see the Cycle Guide).
If you change your mind, press the option
again to turn off the option. Not all options are
available for every cycle. If an invalid option is
selected for a given cycle, the lights will ash.
Adding options may increase the cycle time.
7. Start or resume a cycle
NOTE: If needed, run hot water at the sink nearest your
dishwasher until the water is hot. Turn off water.
Press
START and push the door rmly closed.
IMPORTANT: If the door is opened for any reason after the cycle
is started (even during the delay time), the Start button must be
pressed again after the door is closed. If Start button is not pressed,
the cycle will not resume.
8. Follow the progress of your
dishwasher
The display will indicate the time remaining to complete the cycle
in hours and minutes (HH:MM). When the cycle is complete, the
word Endˮ will be displayed and the Cycle Complete indicator will
be lit and will remain on until the door is opened and closed, or the
Start button is pressed.
CYCLE GUIDE
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for
the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically
compensate by adding time, heat, and water as needed.
For 18-inch models For 24-inch models
CYCLES ESTIMATED
WASH
TIME W/O
OPTIONS
HH:MM
WATER
USAGE
GALLONS
(LITERS)
ESTIMATED
WASH
TIME W/O
OPTIONS
HH:MM
WATER
USAGE
GALLONS
(LITERS)
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and regular
tableware. Includes Heated Dry option.
2:35 5.1 G
(19.2 L)
2.30-2:50 5.8 G
(22.1 L)
This cycle is recommended for daily, regular, or typical use to completely
wash and dry a full load of normally soiled dishes. This dishwasher’s
government energy certications were based on the Normal cycle with
only the Heated Dry option selected.*
1:35-2:10 2.5-4.8 G
(9.3-18.0 L)
1:30-2:10
2.9-5.6 G
(11.1-21.2 L)
Use for lightly soiled items or china and crystal.
1:45 4.0 G
(15.0 L)
1:45 5.0 G
(19.0 L)
Use for lightly soiled loads such as glasses, crystal, and ne china.
Includes a Heated Dry option.
1:35 3.8-4.09 G
(14.4-15.5 L)
1:45 4.9 G
(18.4 L)
For fast results, the Quick cycle will clean prerinsed or lightly soiled
loads that do not need drying. For improved drying, select the Heated
Dry option.
NOTE: Some detergents are not recommended for short wash cycles;
please refer to your detergent packaging for more information.
1:00 3.2 G
(12.3 L)
0:55 4.0 G
(15.0 L)
Use for rinsing dishes, glasses, and silverware that will not be washed
right away. Do not use detergent.
0:20 1.7 G
(6.5 L)
0:10 1.8 G
(6.7 L)
*No other washing and drying temperature options were selected, and the diswasher was not subjected to truncated testing. Rinse aid was not used, and there
was no detergent used in the prewash.
Add rinse aid
indicator
Cycle complete
indicator
Page view 3
1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments