W10286852B .ON TRAPYLNO ESU S’NAICINHCET ECIVRES ROF
TECH SHEET - DO NOT DISCARD PAGE 10
REMOVING THE TOE PANEL
1. Unplug dryer or disconnect power.
2. Remove two screws below the toe
panel.
3. Slide the toe panel down, then pull it
out from the bottom. See figure 14.
ACCESSING & REMOVING
THE ELECTRONIC
ASSEMBLIES
There are two electronic assemblies:
the User Interface and Housing, and
the Machine Control Electronics. See
figure 15.
1. Unplug dryer or disconnect power.
2. Remove the two rear screws from the
top panel, and slide the top panel to
the rear to remove.
Accessing the Machine Control
Electronics
1. After locating the machine control
electronics, remove the screws that
hold the machine control electronics
bracket in place.
Press the locking tab on the bottom
of the machine control electronics and
slide the assembly to the front, then lift.
Accessing the User Interface
and Housing Assembly
1. Access the machine control electronics
(see Accessing the Machine Control
Electronics at left) and disconnect the
P5 ribbon cable.
2. The console panel must be removed
to access the user interface and
housing assembly. Remove the knob
from the front of the console panel.
3. The console panel has two locking tabs
on the left and right rear, one locking
tab on the bottom (hidden), and three
snap releases across the top. See
figure 18. Press the locking tab on the
right rear, and gently rotate the console
panel up as you pull the top free of the
three snap releases, finally pressing the
locking tab on the left, and lift the
console panel off.
2. Slide the bracket over the top of the
drum to access the machine control
electronics connectors and mounting
screw. See figure 16.
Removing the Machine Control
Electronics
1. Remove all the wire connections to the
machine control electronics. See
figure 17.
2. Remove the screw holding the machine
control electronics assembly to the
mounting bracket. See figure 16.
3. There are two plastic legs on the front
of the machine control electronics that
slide under the mounting bracket.
✔ There is one plastic leg on the rear of
the machine control electronics that
slides under the mounting bracket.
✔
There is a locking tab on the bottom
of the machine control electronics
that snaps into the mounting bracket.
N.O.
Black
COM
Red
Heater
Relay 1
Motor
Relay
Tan
Black-White
White
Green-Yellow
Open
Lt. Blue Black
Yellow-Red
Open
Open (Elec.)
Orange (Gas)
Red-White
Red-White
Figure 17. Machine control electronics.
Flange
Figure 14. Pull the toe panel down to
clear flange, then pull panel out.
Locking
Tabs
Snap Releases
User Interface
and Housing Assembly
(inside)
Figure 18. Remove the console panel
to access the user interface and housing
assembly.
➔
If the connections are OK, replace
the wire and door switch assembly
and retest.
➔
If wire and door switch assembly
have been replaced and dryer still
does not start, replace the machine
control electronics.
FRONT
Machine Control
Electronics
Assembly
User Interface
and Housing Assembly
(inside)
Figure 15. Locate the electronic
assemblies.
FRONT
Machine Control
Electronics
Bracket
Machine Control
Electronics
Assembly
Mounting
Screw
Figure 16. Remove machine control
electronics from mounting bracket.
(28 pages)
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals